CRUISE CONTROL
Cruise Control Wiring Diagram for Mitsubishi Montero Sport ES 1998
List of elements for Cruise Control Wiring Diagram for Mitsubishi Montero Sport ES 1998:
- (a/t)
- (right side of dash) j/c 2
- (w/ a/t only)
- 2.4l
- 3.0l
- A/t
- Acc
- Auto-cruise control ecu (behind left kick panel)
- Auto-cruise control main switch
- Auto-cruise vacuum pump (in right rear corner of engine compt)
- C04
- C05
- C27 transmission control module (a/t) (behind left side of dash, above steering column)
- C28
- C67 clutch pedal position switch (m/t) (on bracket, above clutch pedal)
- Cancel
- Clock spring
- Closed throttle plate sw out
- Combination meter
- Cruise indicator
- Cruise on indicator
- D01
- D06
- D13
- D14
- Data link connector (partial) (under left side of dash, near relay box)
- Dedicated fuse 5 10a
- Dedicated fuse 8 15a
- Engine compartment relay box (on left inner fender panel)
- Engine controls system
- Engine controls, transmissions & instrument cluster systems
- Exterior lights system
- G104 (rear of left front fender)
- G200 (behind left kick panel)
- Hot at all times
- Hot in run
- Hot in run or acc
- Hot in run or start
- Ignition switch
- Illumination lamp
- Interior lights system
- Iod or storage connector
- J/c 1 (right side of dash)
- J/c 4 (left side of dash)
- Junction block (behind left side of dash)
- Lock
- M/t
- Multi- purpose fuse 11 10a
- Multi- purpose fuse 4 10a
- Multi- purpose fuse 7 10a
- Nca
- Off
- Park/neutral position switch (on right side of transmission)
- Red
- Resume
- Set
- Start
- Starter relay (in eng compt relay box)
- Stop light switch (on bracket, above brake pedal)
- Throttle position sensor (on throttle body)
- Tp out
- Vehicle speed sensor (on transmission tailshaft)
- Vss out