CRUISE CONTROL
Cruise Control Wiring Diagram for Nissan Cube S 2009
List of elements for Cruise Control Wiring Diagram for Nissan Cube S 2009:
- (left side of dash) bcm (body control module)
- (top of steering column) combination switch (spiral cable)
- A/t
- Abs actuator & electric unit (left rear of engine room)
- Accel/res switch
- Accelerator pedal position sensor
- Aps1
- Aps2
- Ascd brake switch (if equipped) (left side of dash)
- Ascd clutch switch (if equipped) (left side of dash)
- Ascd steering switch (if equipped)
- Ascd sw
- Avcc-aps1
- Avcc-aps2
- Avcc-tps
- Bnc sw
- Brake
- Can-h
- Can-h gnda ascdsw
- Can-l
- Cancel switch
- Closed
- Coast/ set
- Combination meter
- Computer data lines system
- Cruise ind
- Cvt
- Cvt unit
- E15
- E16
- E19
- E21 (right of engine room)
- E38
- Ecm (left rear of engine room)
- Electric throttle control actuator
- Fuse 10a
- Fuse 64 15a
- Fuse block j/b (left side of dash)
- Gnd
- Gnda-aps1
- Gnda-aps2
- Gnda-tps
- Hot at all times
- Hot in on or start
- Ign sig
- Ipdm e/r (intelligent power distribution module engine room) (left side of engine room)
- M/t
- M302
- M33
- M71
- Mot rly
- Motor 1
- Motor 2
- On/off (main) switch
- Open
- Pnk
- Primary speed sensor (cvt: front of engine room)
- Pwr sply
- Red
- Secondary speed sensor (cvt: rear of engine room)
- Sensor 1
- Sensor 2
- Set ind
- Stop lamp switch (left side of dash)
- Switch
- Throttle control motor
- Throttle control motor relay
- Tps1
- Tps2
- Transmission control module (tcm) (cvt: left side of dash)
- Vdc gnd
- Vmot
- W/ intelligent key
- W/o intelligent key