CRUISE CONTROL
Cruise Control Wiring Diagram for Nissan Pathfinder SE 2003
List of elements for Cruise Control Wiring Diagram for Nissan Pathfinder SE 2003:
- (at top left side of engine)
- (behind dash, left of steering column)
- (w/ odo/trip
- 15u
- 17u
- 39u
- A/t
- Ascd brake switch (on bracket, above brake pedal)
- Ascd clutch switch (m/t) (on bracket, above clutch pedal)
- Ascd steering switch
- Ascd sw
- Avcc2
- Bncsw
- Brake
- Can-h
- Can-l
- Cancel switch
- Close
- Combination meter
- Control unit
- Cruise ind lamp
- Electronic throttle control actuator
- Engine control module (ecm) (behind center of dash)
- Fuse & fusible link box
- Fuse 11 7.5a
- Fuse 14 10a
- Fuse 70 15a
- Fuse 8 10a
- Fuse block (j/b)
- Gnd-a
- Gnd-a2
- Hot at all all times
- Hot at all times
- Hot in on or start
- Joint connector
- Lamp
- M/t
- M10
- M147 (behind right side of dash)
- M157 (at upper left kick panel)
- M26
- Main switch
- Meter)
- Motor 1
- Motor 2
- Motrly
- Nca
- Open
- Red
- Resume/accel switch
- Sens gnd
- Sensor 1
- Sensor 2
- Set ind
- Set/coast switch
- Spiral cable
- Stoplight switch (on bracket, above brake pedal)
- Throttle control motor relay (in relay box 2)
- Tps1
- Tps2
- Transmission control module (tcm) (behind dash, left of steering column)
- Unified meter
- Vmot