CRUISE CONTROL – Nissan Quest LE 2012 – SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

Cruise Control Wiring Diagram for Nissan Quest LE 2012

List of elements for Cruise Control Wiring Diagram for Nissan Quest LE 2012:

• Accelerator pedal position sensor (behind left side of dash)
• Acsd steering switch
• Aps1
• Aps1 avcc1
• Aps1 gnda
• Aps2
• Aps2 avcc2
• Aps2 gnda
• Ascd brake switch (behind left side of dash)
• Ascdsw
• Ascdsw gnda
• Bncsw
• Brake
• Can-h
• Can-l
• Cancel
• Close
• Combination meter
• Combination switch (spiral cable)
• Computer data lines system
• Cruise ind
• Cvt unit
• E10
• E103
• E105
• E16
• E21 (rear of engine)
• E38 (rear of engine)
• Ecm (front left side of engine)
• Electric throttle control actuator (right rear of engine compt)
• F12
• Fuse 10a
• Fuse 51 15a
• Fuse block (j/b) (behind left side of dash)
• Gnd
• Hot at all times
• Hot w/ ignition relay energized
• Ipdm e/r (intelligent power distribution module engine room) (left side of engine compt)
• M11
• M303
• M33
• Main (on/off)
• Motor 1
• Motor 2
• Motrly
• Nca
• Open
• Pnk
• Pri spd sens
• Primary speed sensor
• Red
• Resume/ accelerate
• Sec spd sens
• Secondary speed sensor
• Sens gnd
• Sens pwr
• Sensor 1
• Sensor 2
• Set/ coast
• Stop lamp relay
• Stop lamp switch
• Tcm (transmission control module) (left front of engine compt)
• Throttle control motor
• Throttle control motor relay
• Throttle position sensor
• Tps avcc1
• Tps gnda
• Tps1
• Tps2
• Vbr
• Veh can-h
• Veh can-l
• Vmot