CRUISE CONTROL – Nissan Quest XE 1997 – SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

Cruise Control Wiring Diagram for Nissan Quest XE 1997

List of elements for Cruise Control Wiring Diagram for Nissan Quest XE 1997:

• A/t control unit (right side of dash)
• Act. cntrl
• Actuator control
• Air valve solenoid
• Ascd actuator (right front fender)
• Ascd cancel switch (top of brake
• Ascd control module (below center
• Ascd hold relay (fuse & fusible link box)
• Ascd main switch
• Ascd steering switch
• Ascd sw.
• Cancel
• Console)
• Crs. cancl
• Cruise ind.
• Cruise signal
• Diode j/c 1 (left side of dash)
• Electric speed- ometer
• Fuse 22 15a
• Fuse 29 10a
• Fuse 30 10a
• Fuse 44 15a
• Fuse block (left side of dash)
• G104 (left front fender)
• G104 (rear of left front fender)
• G202 (left side of dash)
• G206 (center of dash)
• G302 (below center console)
• Ground
• Horn relay (relay box, left front of engine compartment)
• Horns system
• Hot at all times
• Hot in on or start
• Inhibitor relay (relay box, left front of engine compartment)
• Inhibitor switch (top of transmission)
• Instrument cluster
• Interior lights system
• J/c 1 (in fuse & fusible link box)
• J/c 3 (left side of dash)
• Lt gn/bk
• Nca
• Od cut
• Od cut signal
• Off
• Pedal support)
• Pnk
• Release valve solenoid
• Resume/ accelerate
• Set/coast
• Speed
• Spiral cable
• St lmp sw.
• Steering switch
• Stop lamp switch (top of brake pedal support)
• Theft warning relay (relay box)
• Vacuum motor
• Vehicle speed sensor (top of trans.)
• W/ theft
• W/o theft