ENGINE PERFORMANCE – Mitsubishi Montero LS 1995 – SYSTEM WIRING DIAGRAMS

ENGINE PERFORMANCE

3.0L

3.0L 12 Valve, Engine Performance Wiring Diagrams (1 of 2) for Mitsubishi Montero LS 1995

List of elements for 3.0L 12 Valve, Engine Performance Wiring Diagrams (1 of 2) for Mitsubishi Montero LS 1995:

• air conditioning compressor relay
• (right kick panel)
• (w/ a/t)
• (w/ m/t)
• A09x
• Abs control unit pin 38
• Abs relay box pin 4 (motor relay)
• Acc
• Air conditioning engine coolant temperature switch
• C04
• C06
• C101
• C11
• C12
• C56
• C62-3
• C81
• C82
• C94
• C96
• C99
• Capacitor (no loc avail)
• Check engine
• Clutch pedal position switch
• Data link connector(s) (below left i/p)
• Engine control relay (below right side of dash, at kick panel)
• Fuel injectors
• Fuel pump (in top side of fuel tank)
• Fuel pump check connector (right rear of engine compartment)
• Fuse 10a
• Fusible link
• Fusible link 6 20a
• G201 (right of glove box)
• G201 (w/ m/t) (right side of i/p, left of glove box)
• G202 (lower left side of i/p)
• G202 (w/ m/t) (lower left side of i/p)
• G203 (right kick panel)
• G312 (behind left rear seat)
• Hot at all times
• Ignition switch
• Ignition timing adjust connector (right rear of engine compt)
• Instrument cluster
• Iod or storage conn- ector
• J/c 1 c62-1
• J/c 2 c62-2
• J/c 3
• Junction block
• Lock
• No.1
• No.2
• No.3
• No.4
• No.5
• No.6
• Park/ neutral position switch (right side of engine compt)
• Pnk
• Powertrain control module
• Red
• Relay box: engine compt
• Start
• Starter relay (behind center dash panel)
• Tachometer
• Vehicle speed sensor (reed)
• W/ a/t
• W/ a/t w/ m/t
• W/ m/t
• With a/t
• With m/t

3.0L 12 Valve, Engine Performance Wiring Diagrams (2 of 2) for Mitsubishi Montero LS 1995

List of elements for 3.0L 12 Valve, Engine Performance Wiring Diagrams (2 of 2) for Mitsubishi Montero LS 1995:

• Barometric pressure sensor
• Camshaft position sensor
• Closed throttle position switch
• Crankshaft position sensor
• Cruise control unit
• Distributor
• Distributor signal generator (inside distributor assembly)
• Engine coolant temperature sensor (left center of engine compartment)
• Evaporative emission purge solenoid (left rear of engine compartment)
• G110 (lower left front of engine compartmemt)
• G203 (behind right kick panel)
• Heated oxygen sensor (right rear of engine compartment, in exhaust pipe)
• Idle air control motor (right center of engine compartment)
• Ignition coil (left side of engine compart-
• Ignition power transistor (top center of engine)
• Intake air temperature sensor
• Ment)
• Nca
• Noise filter (right rear of engine) compart- ment)
• Pin 4
• Pin 5
• Pnk
• Power steering pressure switch (lower left front of engine compartment) (w/ a/t)
• Throttle position sensor (right center of engine engine compartment, on intake assembly)
• Volume air flow sensor
• Volume air flow sensor (right side of engine compartment, in air intake plenum)

3.0L 24 Valve, Engine Performance Wiring Diagrams (1 of 3) for Mitsubishi Montero LS 1995

List of elements for 3.0L 24 Valve, Engine Performance Wiring Diagrams (1 of 3) for Mitsubishi Montero LS 1995:

• (left side of i/p)
• (right rear of engine compt.) fuel pump check connector
• A/c compressor clutch relay
• A/c compressor clutch relay & dual pressure switch
• A42
• A42-1
• Abs control unit
• Abs control unit (pin 38)
• Abs motor relay (coil)
• C21
• C38
• Data link connector (partial) (below i/p, left of steering column)
• Elc-4a/t control module
• Engine compart- ment relay box
• Engine speed detection connector (right rear of engine compt.)
• Fuel injectors (top of engine)
• Fuel pump
• Fusible link 6 20a
• G100 (front of left front fender)
• G203 (right kick panel)
• G402 (left rear wheel well)
• Hot at all times
• Ignition coils
• Ignition power transistor
• Ignition timing adjustment connector
• J/c (1) c62-1
• Multiport fuel injection relay (behind right side of i/p)
• Power steering oil pressure switch
• Powertrain control module (right kick panel)
• Red
• Spark plugs 1 & 4
• Spark plugs 2 & 5
• Spark plugs 3 & 6
• Tachometer

3.0L 24 Valve, Engine Performance Wiring Diagrams (2 of 3) for Mitsubishi Montero LS 1995

List of elements for 3.0L 24 Valve, Engine Performance Wiring Diagrams (2 of 3) for Mitsubishi Montero LS 1995:

• (left side (of i/p) j/c #2
• (right side of engine, below throttle body) idle speed control motor
• A/t
• Acc
• C101
• C12
• C62-2
• C96
• Check engine indicator
• Cluster
• Cruise control unit
• G202 (left side of i/p)
• G206 (center of i/p)
• Generator relay
• Hot at all times
• Ignition switch
• Instrument
• J/c (3) c62-3 (left side of i/p)
• Junction block (left side of i/p)
• Lock
• M/t
• Multi- purpose fuse 11 10a
• Nca
• Park/ neutral position switch (side of transmission)
• Red
• Start
• Starter
• Vehicle speed sensor (reed switch)

3.0L 24 Valve, Engine Performance Wiring Diagrams (3 of 3) for Mitsubishi Montero LS 1995

List of elements for 3.0L 24 Valve, Engine Performance Wiring Diagrams (3 of 3) for Mitsubishi Montero LS 1995:

• (after catalytic converter)
• (before catalytic converter)
• (fed. only)
• (left side of engine compt.)
• * california
• Atmospheric sensor
• Block
• C37
• C62-1
• C81
• C94
• C96
• Camshaft position sensor (left side of engine)
• Crankshaft position sensor (left side of engine)
• Cruise control unit
• Elc-4a/t control module
• Engine coolant temperature sensor (right side of engine)
• Evaporative emission purge solenoid (l)
• Evaporative emission purge solenoid (s)
• G203 (right kick panel)
• Hot at all times
• Intake air temp sens
• Iod or storage connector
• J/c #1 (left side of i/p)
• Junction
• Left bank heated oxygen sensor (front)
• Left bank heated oxygen sensor (rear)
• Models only
• Multi- purpose fuse 19 10a
• Nca
• Open throttle
• Pnk
• Powertrain control module (right kick panel)
• Red
• Right bank heated oxygen sensor (front)
• Right bank heated oxygen sensor (rear)
• Throttle position sensor (right side of engine)
• Volume air flow sensor (right center of engine compt)

3.5L

3.5L, Engine Performance Wiring Diagrams (1 of 3) for Mitsubishi Montero LS 1995

List of elements for 3.5L, Engine Performance Wiring Diagrams (1 of 3) for Mitsubishi Montero LS 1995:

• (calif. only)
• (left side of i/p)
• (near oil filler cap)
• (right rear of engine compt.) fuel pump check connector
• A/c compressor clutch relay
• A/c compressor clutch relay & dual pressure switch
• A42
• A42-1
• Abs control unit
• Abs control unit (pin 38)
• Abs motor relay (coil)
• C21
• C38
• Data link connector (partial) (below i/p, left of steering column)
• Elc-4a/t control module
• Engine compart- ment relay box
• Engine speed detection connector (right rear of engine compt.)
• Fuel injectors (top of engine)
• Fuel pump
• Fusible link 6 20a
• G100 (front of left front fender)
• G203 (right kick panel)
• G402 (left rear wheel well)
• Hot at all times
• Ignition coils
• Ignition power transistor
• Ignition timing adjustment connector
• J/c (1) c62-1
• Multiport fuel injection relay (behind right side of i/p)
• Nca
• Power steering oil pressure switch
• Powertrain control module (right kick panel)
• Red
• Spark plugs 1 & 4
• Spark plugs 2 & 5
• Spark plugs 6 & 3
• Tachometer
• Variable induction control solenoid

3.5L, Engine Performance Wiring Diagrams (2 of 3) for Mitsubishi Montero LS 1995

List of elements for 3.5L, Engine Performance Wiring Diagrams (2 of 3) for Mitsubishi Montero LS 1995:

• (left side
• (left side (of i/p) j/c #2
• (left side of i/p)
• (right side of engine, below throttle body) idle speed control motor
• Abs control unit
• Acc
• C101
• C12
• C62-2
• C80
• C96
• C97
• Check engine indicator
• Cruise control unit
• Dedicated fuse 5
• Defogger & mirror heater
• Defogger relay
• Diode (c39)
• G206 (center of i/p)
• Generator relay
• Hot at all times
• Ignition switch
• Instrument cluster
• J/c #1 c62-1
• J/c #3 c62-3
• Junction block (left side of i/p)
• Lock
• Multi- purpose fuse 11 10a
• Nca
• Park/ neutral position switch (side of transmission)
• Red
• Start
• Starter
• Stop light switch
• Vehicle speed sensor (reed switch)

3.5L, Engine Performance Wiring Diagrams (3 of 3) for Mitsubishi Montero LS 1995

List of elements for 3.5L, Engine Performance Wiring Diagrams (3 of 3) for Mitsubishi Montero LS 1995:

• (after catalytic converter)
• (before catalytic converter)
• (left side of engine compt.) evaporative emission purge solenoid
• (right front of engine compt.) egr solenoid
• * california
• Atmospheric sensor
• Block
• C37
• C62-1
• C81
• C94
• C96
• Camshaft position sensor (left side of engine)
• Crankshaft position sensor (left side of engine)
• Cruise control unit
• Egr temperature sensor (right side of engine)
• Elc-4a/t control module
• Engine coolant temperature sensor (right side of engine)
• G100 (front of left front fender)
• G203 (right kick panel)
• Heated oxygen sensor (front)
• Heated oxygen sensor (rear)
• Hot at all times
• Intake air temp sens
• Iod or storage connector
• J/c #1 (left side of i/p)
• Junction
• Knock sensor
• Models only
• Multi- purpose fuse 19 10a
• Nca
• Open throttle
• Pnk
• Powertrain control module (right kick panel)
• Red
• Throttle position sensor (right side of engine)
• Volume air flow sensor (right center of engine compt)