CRUISE CONTROL – Chevrolet Silverado 2500 HD 2001 – SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

Cruise Control Wiring Diagram for Chevrolet Silverado 2500 HD 2001

List of elements for Cruise Control Wiring Diagram for Chevrolet Silverado 2500 HD 2001:

• (36 series only)
• (power take off)
• 5 volt ref
• A12
• A13
• A14
• A15
• Accelerator pedal position sensor (above accelerator pedal)
• Act cntrl
• App sens
• App sens 1
• App sens 2
• App sens 3
• App sense
• C1 d11
• C2 a10
• Clutch pedal position switch (top of clutch pedal)
• Clutch sw input
• Cruise control on/off switch
• Cruise fuse 10a
• Cruise req
• Ect fuse 15a
• Engine compt)
• Engine controls system
• F12
• Fuse block (on lower left side of dash)
• G117 (right rear of engine)
• Ground
• Hot at all times
• Hot in run & start
• Ign
• Nca
• Off
• Pnk
• Powertrain control module (left front of engine compt)
• R/a input
• Resume/accel
• S/c input
• S103
• Sens 1 grd
• Sens 1 rt
• Sens 2 grd
• Sens 2 rt
• Sens 3 grd
• Sens 3 rt
• Serial data
• Set/coast
• Stop lps fuse 20a
• Stoplamp switch (on top of brake pedal bracket)
• Stp lp in
• Tan
• Throttle actuator control (tac) module (near front of engine compt)
• Throttle actuator control motor (near front of
• Throttle position sensor (near front of engine compartment)
• Tp sens 1
• Tp sens 2
• Underhood junction block (left side of engine compt, near battery)
• Veh stop fuse 10a
• Vehicle speed sensor (vss) (2wd: left rear side of transmission) (4wd: left rear side of transfer case)
• Vehicle speed sensor adapter (4wd) (on left side of transmission)
• Vss high
• Vss low