CRUISE CONTROL – Ford Explorer Sport Trac 2003 – SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

Cruise Control Wiring Diagram for Ford Explorer Sport Trac 2003

List of elements for Cruise Control Wiring Diagram for Ford Explorer Sport Trac 2003:

• (at left center of engine compartment)
• (m/t) (a/t)
• (sport trac)
• (under left side of dash)
• A/t
• Air bag sliding contact
• Battery junction box (bjb) (left side of engine compartment, at fender apron)
• Brake pedal position switch (above brake pedal)
• Brake press input
• Brake pressure switch
• C2100a
• C218a
• C220a
• C220b
• C274a
• C281b
• Central junction box (cjb) (behind left side of dash)
• Central security module (w/ convenience group) (behind top right side of dash)
• Clutch pedal position switch (above clutch pedal)
• Coast
• Four-wheel drive control module (at right kick panel)
• Fuse 15a
• Fuse 2a
• Fuse 7.5a
• G105 (at right center of engine compartment)
• G204 (at left kick panel)
• G300 (at left kick panel)
• Generic electronic module (gem) (behind center of dash)
• Ground
• Horn
• Horn relay
• Hot at all times
• Hot in run
• Ignition
• Indicator control
• Instrument cluster
• Interior lights system
• M/t
• Nca
• Off
• Output shaft speed (oss) sensor (on rear of transmission)
• Overhead console
• Powertrain control module (pcm) (mounted through firewall)
• Red/
• Rest
• Resume
• S116
• S127
• S143 (at center rear of engine compt)
• S206
• S213 (behind instrument cluster)
• S214
• S216
• S227
• Set/ acc
• Speed cont sw gnd
• Speed cont sw in
• Speed control indicator
• Speed control servo (on right rear of engine compartment)
• Steering wheel/ speed control switch
• Vehicle speed input