CRUISE CONTROL
4.0L
4.0L, Cruise Control Wiring Diagram for Ford Explorer 1994
List of elements for 4.0L, Cruise Control Wiring Diagram for Ford Explorer 1994:
- (attached to transmission)
- (behind left side of instrument panel, taped to main harness)
- (behind steering column)
- (connects to throttle linkage)
- (left side of engine, at fender apron)
- (on clutch pedal arm)
- (right side of
- (under right side
- 15a
- 40-
- 50,000 ohms
- 60-
- A/t
- Accel
- Actuator
- All
- Amp disable input
- Amp feedback
- Amp input
- Brake on/off (boo) switch
- Clock- ring
- Clutch triple function switch
- Clutch triple function switch jumper
- Coast
- Common
- Control switch input
- Cruise control amplifier (behind right side of instrument panel)
- Cruise control servo
- Engine controls system
- Fast
- Fuse 4
- Fuse 6 10a
- G201
- G203
- Ground
- Hazard flasher (part of interior fuse panel)
- Horn
- Horns system
- Hot at all times
- Hot in accy or run
- Instrument panel,
- Interior fuse panel
- Keyless entry system
- Limited edition
- Limited edition & electronic group only
- M/t
- Mounted to right side of kick panel)
- Of dash, above pcm)
- Off
- Ohms
- Others
- Overhead console system
- Pnk/
- Remote keyless entry & anti-theft systems
- Resume
- Servo feedback
- Servo motor
- Set/
- Slow
- Sol+
- Speed control/ horn switch (in steering column assembly)
- Speed sensor input
- Vac
- Vac solenoid
- Vacuum distri- bution
- Vacuum dump valve (vents to atmosphere when brake is depressed)
- Vehicle power
- Vehicle speed sensor (vss) (200-300 ohms)
- Vent
- Vent solenoid