CRUISE CONTROL — Dodge Dakota 2003 — SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

Cruise Control Wiring Diagram for Dodge Dakota 2003

List of elements for Cruise Control Wiring Diagram for Dodge Dakota 2003:

• (3.9l: rear of engine) (5.9l/4.7l: left rear of engine) s103
• (in engine compt, on right inner fender panel) powertrain control module
• (on right fender side shield) g112
• (right front of engine compt) vehicle speed control servo
• 3.9l/5.9l
• 4.7l
• Accel/ resume
• Brake lamp switch (on brake pedal bracket)
• Cancel
• Clockspring (top of steering column, below steering wheel)
• Coast
• Cruise control lamp control
• Cruise indicator
• D25
• Data link connector (under dash, left of steering column)
• Dump
• Fuse 10a
• Fused ign
• Hot in run or start
• Instrument cluster
• Joint connector 3 (in pdc)
• Junction block (left end of dash)
• Left speed control switch
• Nca
• On/off
• Pci bus
• Right speed control switch
• S201 (behind left side of dash)
• S202 (behind right side of dash)
• Sensor gnd
• Set
• Speed sw sig
• Tan/red
• V32
• V35
• V36
• V37
• Vacuum
• Vacuum sol
• Vent
• Vent sol