TRANSMISSION – Nissan 240SX SE 1997 – SYSTEM WIRING DIAGRAMS

TRANSMISSION

A/T Wiring Diagram for Nissan 240SX SE 1997

List of elements for A/T Wiring Diagram for Nissan 240SX SE 1997:

• 1 pos
• 1995 vftc c
• 2 pos
• A/t control unit (behind dash, left of steering column)
• A/t fluid temperature sensor
• All times
• Ascd control unit (behind right kick panel)
• Ascd unit
• Atck
• Automatic transmission
• Avcc
• Closed
• Cluster system
• Combination meter
• D pos
• Data clk
• Data in
• Data link connector (for consult) (left kick panel)
• Data out
• Dropping resistor (left front of engine compt)
• Dt1
• Dt2
• Dt3
• Duty sol
• Eng rev
• Engine control module (ecm) (behind right kick panel)
• Engine coolant temperature sensor (top right front of engine)
• Fl temp
• Full sw
• Fuse 7.5a
• Fuse block (left kick panel)
• G125 (front of engine)
• G300 (below left front seat)
• Gnd
• Gnd a
• Hot at
• Hot in on or start
• Idle sw
• Inhibitor switch (right side of transmission)
• Instrument
• Line pressure solenoid valve
• Mem b/u
• N pos
• N sig
• Nca
• Neut
• O/d off ind
• Obd2
• Od cont
• Od off
• Overdrive control switch
• Overrun clutch solenoid
• Ovr/c
• Pnk
• R pos
• Red
• Revolution sensor (left side of transmission)
• Sens gnd
• Sens pwr
• Shift solenoid valve a
• Shift solenoid valve b
• Speedo
• Speedometer
• Ssa
• Ssb
• Tacho
• Th/sen
• Throttle position sensor (on throttle body)
• Throttle position switch (on throttle body)
• Torque converter clutch solenoid valve
• Tv01
• Tvoo
• Vehicle speed sensor (right rear of transmission)
• Vign
• Vsp-1
• Wide open