TRANSMISSION – Jaguar XJR 1998 – SYSTEM WIRING DIAGRAMS

TRANSMISSION

A/T Wiring Diagram for Jaguar XJR 1998

List of elements for A/T Wiring Diagram for Jaguar XJR 1998:

• (center of dash, on firewall) g206
• (open in p or n)
• 1-2/ 4-5
• 2-3
• 3-4
• Body processor module (behind glove box)
• Ca1
• Can data +
• Can data -
• Can network
• Common voltage
• Computer data lines system
• Dual linear sw
• Dual linear switch (in center console)
• Em61
• Em62
• Enclosure) em10
• Engine compartment fuse box (left front of eng compt)
• Engine control module (engine compartment, control module p, n sig
• Fld temp sens
• Fluid temp sensor
• Fuse 10a
• G100 (front of left front fender)
• G206 (center of dash, on firewall)
• G302 (left side of transmission tunnel)
• Gear selector illumination module (in center console)
• Hot in run or start
• Ignition
• Interior lights system
• Kickdown sw
• Kickdown switch (under accelerator pedal)
• Left heelboard fuse box (on left side of heelboard)
• Lsb
• Mod press reg
• Mode switch
• N2 sp sen fb
• N2 speed sensor
• N3 sd sen fb
• N3 speed sensor
• Nuetral sw status
• Pressure regulators
• Programming
• Programming circuit is for early production models
• Sensor common
• Shift press reg
• Sol activate
• Solenoid valves
• Sp sen common
• Sprt mode sw
• Tcc sol act
• Tcc solenoid
• Tcm programming via link connector
• Tcm/dual lin
• Transmission
• Transmission control module (in eng compt control module enclosure)