ANTI-LOCK BRAKES
Anti-lock Brakes Wiring Diagram for Isuzu i-370 LS 2008
List of elements for Anti-lock Brakes Wiring Diagram for Isuzu i-370 LS 2008:
- 2wd
- A11 x7
- A17
- A26
- A31
- A39
- A45
- Abs 1 fuse 30a
- Abs 2 fuse 40a
- Abs fuse 10a
- Abs ind
- Accessory switch
- B x5
- Body control module (bcm) (behind right kick panel)
- Brake fluid level switch (on brake fluid reservoir)
- Brake fluid lvl sens sig
- Brake ind
- Class 2 serial data
- Computer data lines system
- Del torque sig (nw7)
- Delivered torque signal
- Driver info center
- Electronic brake control module (ebcm) (on inner left frame rail, beside transmission)
- Engine control module (ecm) (right rear of engine compt)
- G105
- G106
- Gnd
- Hot at all times
- Hot in run or start
- Ign
- Ign voltage
- Instrument panel cluster (ipc)
- Interior lights system
- J100 (body harness, 14.5 cm from accelerator pedal position switch breakout)
- J200
- Jx105 (left side of engine compt)
- Jx106 (right side of engine compt)
- Left front wheel speed sensor (wss) (on left front hub)
- Lf whl spd control
- Lf whl spd sens sig
- Lng rate sig (4wd)
- Logic
- Longitudinal accelerometer sensor (4wd) (under driver seat, below carpet)
- Low ref (4wd
- Park brake switch (lower left end of dash)
- Park brk sw sig
- Pnk
- Red
- Req torque sig (nw7)
- Requested torque signal
- Rf whl spd control
- Rf whl spd sens sig
- Right front wheel speed sensor (wss) (on right front hub)
- Stability caution ind
- Stop fuse 20a
- Stop lamp switch (above brake pedal assembly)
- Stop lmp control
- Tan
- Tcs req indicator ctrl
- Trac ctrl sw sig
- Underhood fuse block (left front side of engine compt)
- Vss