INSTRUMENT CLUSTER – Isuzu i-290 S 2008 – SYSTEM WIRING DIAGRAMS

INSTRUMENT CLUSTER

Instrument Cluster Wiring Diagram for Isuzu i-290 S 2008

List of elements for Instrument Cluster Wiring Diagram for Isuzu i-290 S 2008:

• (chassis harness, 39 cm before fuel pump & sender assembly)
• (or tan)
• (right rear of engine compt) engine control module (ecm)
• (under driver seat carpet) g300
• A19
• A31
• A38
• A39
• A41
• A42
• A44
• A45
• A47
• Abs ind
• Air bag ind
• Battery
• Body control module (bcm) (behind right kick panel)
• Brake fluid level switch (on brake fluid reservoir)
• Brake ind
• Brk fluid lvl
• Chime
• Class 2
• Clstr fuse 10a
• Computer data lines system
• Cruise ind
• Dr belt sw
• Driver seat belt buckle (right side of driver's seat)
• Driver seat belt switch
• Drl ind
• Ect sens
• Engine controls system
• Engine coolant
• Engine coolant temperature gauge
• Engine oil pressure (eop) switch
• Fuel gauge
• Fuel level
• Fuel pump & sender assembly (top of fuel tank)
• G105
• Ground
• High beam ind
• Hot at all times
• Ign
• Illumination (4 bulbs)
• Inflatable restraint sensing & diagnostic module (beneath center console)
• Instrument panel cluster (ipc)
• J201
• J310
• J311 (body harness, 24.5 cm from g302 breakout)
• Jx105 (left side of engine compt)
• L turn ind
• Left turn ind
• Low engine oil pressure gauge
• Low engine oil pressure ind
• Low ref
• Malfunction ind
• Mil ctrl
• Nca
• Oil press
• Park brake switch (lower left end of dash)
• Pnk
• Prk brk sw
• R turn ind
• Right turn ind
• Seat belt ind
• Security ind
• Serial data
• Speedometer
• Tachometer
• Temperature (ect) sensor (on left rear of engine)
• Underhood fuse block (left front side of engine compt)
• Up shift ind
• Volts