ANTI-LOCK BRAKES – Chrysler Sebring Touring 2005 – SYSTEM WIRING DIAGRAMS

ANTI-LOCK BRAKES

Anti-lock Brakes Wiring Diagram for Chrysler Sebring Touring 2005

List of elements for Anti-lock Brakes Wiring Diagram for Chrysler Sebring Touring 2005:

• A10
• A20
• Abs warning ind control
• Abs warning indicator
• Anti-lock brake module (at lower left front of engine compt)
• Body control module (at left kick panel)
• Brake fluid level switch (at left rear of engine compt)
• Brake lamp sw
• Brake lamp switch (at top of brake pedal assembly)
• Brake warning ind
• Brake warning ind driver
• Brake warning indicator
• D25
• Daytime running lamp module
• F12
• Fuse 10a
• Fuse 20a
• Fuse 40a
• Fused b (+)
• Fused ign sw input
• G103 (near left front strut tower)
• G113 (near left headlight)
• Ground
• Hot at all times
• Hot in run or start
• Ign sw (run-start)
• Instrument cluster
• Junction block (left end of dash)
• L50
• Left front wheel speed sensor (at left side of engine compt)
• Left rear wheel speed sensor (at left rear wheelwell)
• Lf whl spd 12v
• Lf whl spd sig
• Lr whl spd 12v
• Lr whl spd sig
• Park brake switch (at base of parking brake lever)
• Pci bus
• Power distribution center (on left front inner fender)
• Red
• Rf whl spd 12v
• Rf whl spd sig
• Right front wheel speed sensor (at right side of engine compt)
• Right rear wheel speed sensor (at right rear wheelwell)
• Rr whl spd 12v
• Rr whl spd sig
• S105
• S210
• Z101
• Z102