ANTI-THEFT – Chrysler Cirrus LXi 1999 – SYSTEM WIRING DIAGRAMS

ANTI-THEFT

Anti-theft Wiring Diagram for Chrysler Cirrus LXi 1999

List of elements for Anti-theft Wiring Diagram for Chrysler Cirrus LXi 1999:

• A15
• Arm
• Body control module
• C10
• C4 c4
• Ccd bus (+)
• Ccd bus (-)
• Combinaton flasher (part of multi- function switch)
• Courtesy lamps control
• Disarm
• Dr ajar sense
• F18
• Fuse (b+)
• Fuse 10a
• Fuse 20a
• Fused b(+)
• Fused ign
• G103 (right front strut tower)
• G200 (left kick panel)
• G406 (center of deck lid)
• G69
• G71
• G72
• G73
• G74
• G75
• Ground
• Hdlmp relay control
• Headlamp switch (part of multi- function switch)
• Headlights system (headlamp delay relay)
• High note horn (right front fender)
• Horn relay
• Horn relay control
• Horns system (horn switches)
• Hot at all times
• Hot in run or start
• Instrument cluster
• Instrument cluster system
• Interior lights system
• Junction block (under left side of dash)
• Junction block (under left side of dash) c9
• Lamp driver
• Left cylinder lock switch
• Left front door ajar switch
• Left rear door ajar switch
• Low note horn (right front fender)
• Lt dr arm/ disarm sense
• Off
• Pnk
• Pnk/red
• Power distribution center (on left front inner fender)
• Powertrain control module (left fender side shield, attached to power dist center)
• Right cylinder lock switch
• Right front door ajar switch
• Right rear door ajar switch
• Rt dr arm/ disarm sense
• S106
• S111
• S301
• S400
• S401
• Sentry key immobilizer module (near ignition lock cylinder)
• Tan
• Tan/pnk
• Tan/red
• Trunk key cylinder switch
• Trunk lock cyl sense
• Vehicle theft security system set l.e.d.