TRANSMISSION – Chrysler Cirrus LXi 1999 – SYSTEM WIRING DIAGRAMS

TRANSMISSION

A/T Wiring Diagram (1 of 3) for Chrysler Cirrus LXi 1999

List of elements for A/T Wiring Diagram (1 of 3) for Chrysler Cirrus LXi 1999:

• (eng harn, near tcm breakout)
• (eng harn, near tss breakout)
• 2-4 press sw
• 2-4 pressure switch
• 2-4 sol ctrl
• 2-4 solenoid
• A24
• A41
• Auto stick dn
• Body control module
• Ccd bus (+)
• Ccd bus (-)
• Ckp sens sig
• D21
• F11
• Fuse 11 10a
• Fused (b+)
• Fused ign out
• G102 (left front strut tower)
• Gnd
• Ground
• Hot in off, run or start
• Input spd sns
• Junction block
• K22
• K24
• Low/ reverse pressure switch
• Low/ reverse solenoid
• Low/rev press
• Low/rev sol
• Od press sw
• Od sol
• Output shaft speed sensor (on left side of transmission case)
• Output spd sns
• Over- drive solenoid
• Overdrive pressure switch
• Pnp sw sense
• S100
• S101
• S125
• Sci receive
• Sci transmit
• Sensor gnd
• Spd sensor gnd
• T10
• T13
• T14
• T15
• T16
• T19
• T20
• T41
• T42
• T44
• T47
• T50
• T52
• T54
• T59
• T60
• Torq mgmt req
• Tps sig
• Tr rng t42 sens
• Tr sw t1 sense
• Trans rly out
• Trans temp sig
• Transmission control module (left fender side shield, attached to power distribution center)
• Transmission solenoid & pressure switch assembly (transmission)
• Turbine speed sensor (on trans- mission left of manual shift lever)
• Ud sol
• Under- drive solenoid
• Upshift sw
• Vss sig
• Z13
• Z14

A/T Wiring Diagram (2 of 3) for Chrysler Cirrus LXi 1999

List of elements for A/T Wiring Diagram (2 of 3) for Chrysler Cirrus LXi 1999:

• (left front strut tower) g102
• (left side of dash) junction block
• Acc
• Automatic shutdown relay
• Autostick switch (integral with gearshift mechanism)
• Back-up lamp switch
• Engine starter motor relay, fuel pump relay
• Exterior lights system (back-up lamps)
• Fuse 3 20a
• Fuse 5 20a
• Fuse 8 20a
• G200 (left kick panel)
• Hall effect switches
• Hot at all times
• Ignition switch
• Lock
• Nol
• Off
• P3l
• Power distribution center
• Prnl
• Red
• Red/ tan
• Red/tan
• Run
• S101
• S102
• S104
• Start
• Trans temp sensor
• Transmission control relay
• Transmission range switch (in transmission, on top of valve body)

A/T Wiring Diagram (3 of 3) for Chrysler Cirrus LXi 1999

List of elements for A/T Wiring Diagram (3 of 3) for Chrysler Cirrus LXi 1999:

• (eng harn, 2.0l/2.4l: near cam sensor breakout, 2.5l: near iac motor breakout)
• (eng harn, 2.0l/2.4l: near map/iat sensor breakout, 2.5l: near egr breakout)
• (eng harn, 2.0l/2.4l: near map/iat sensor breakout, 2.5l: near inj 6 breakout)
• (eng harn, near pcm breakout)
• (eng harn, near stop lamp switch breakout)
• (in power distribution center) engine starter motor relay
• (left front strut tower) g102
• 2.0l & 2.4l
• 2.5l
• A14
• Anti-lock brakes system
• Ccd bus (+)
• Ccd bus (-)
• Ckp sensor sig
• Crankshaft position sensor
• D21
• Data link connector (on left
• Ect sensor sig
• Engine controls system
• Engine coolant temperature sensor (2.0l/2.4l: top left front of eng, 2.5l: rear of eng, next to coolant fill neck)
• F12
• Fuel pump relay, controller anti-lock brake
• Fuse 10a
• Fuse 15a
• Fused b (+)
• Gnd
• Hot in run
• Hot in run & start
• Ign (run/start)
• Junction block
• K22
• K24
• K29
• Kick panel, above hood release)
• P/n sw sense
• Power distribution center
• Powertrain control module (left fender side shield, attached to power distribution center)
• Red/tan
• S101
• S105
• S110 (eng harn, inside power distribution center)
• S115
• S116
• S117
• S120
• S121 (eng harn, near pcm breakout)
• S129
• Sci transmit
• Sensor gnd
• Speed proportional steering module
• Stop lamp switch (top of brake pedal)
• Stop lp sw sense
• T10
• T41
• Throttle position sensor (on side of throttle body)
• Torque req sense
• Tp sens sig
• Vss signal
• Z12