INSTRUMENT CLUSTER – Chrysler Cirrus LXi 1999 – SYSTEM WIRING DIAGRAMS

INSTRUMENT CLUSTER

Instrument Cluster Wiring Diagram (1 of 2) for Chrysler Cirrus LXi 1999

List of elements for Instrument Cluster Wiring Diagram (1 of 2) for Chrysler Cirrus LXi 1999:

72

• (fog lamps) headlights system
• Abs warning indicator
• Air bag warning lamp
• Air bag warning lamp control
• Anti-theft system
• B10
• B11
• B12
• B13
• Body control module
• Brake shift interlock solenoid
• Brake warning indicator
• C1 (conn a)
• C2 (conn b)
• Ccd bus (+)
• Ccd bus (-)
• Charging system warning lamp
• Charging system warning lamp control
• Cruise (vehicle speed control) engaged lamp control
• Cruise engaged lamp
• Engine coolant temperature gauge
• Engine coolant temperature gauge control
• Engine coolant temperature lamp
• Engine coolant temperature lamp control
• Exterior lights system
• Exterior lights system
• Fog lamp indicator
• Fuel gauge
• Fuel gauge control
• Fuse 11 10a
• Fuse 7 20a
• Fuse 9 10a
• Fused (b+)
• Fused ign in
• G200 (left kick panel)
• Ground
• High beam indicator lamp
• High beam indicator lamp control
• Hot at all times
• Hot in off,
• Hot in run or start
• Illumination
• Instrument cluster
• Junction block (under left side of dash)
• Left turn signal indicator
• Low fuel warning lamp
• Low fuel warning lamp control
• Malfunction indicator lamp (check engine)
• Malfunction indicator lamp control (check engine)
• Odometer control
• Odometer/ trip
• Oil pressure indicator
• Only
• P r n d l
• Panel lamps driver
• Pnk/ red
• Pnk/red
• Power distribution center (left front inner fender)
• Prndl control
• Prndl/ autostick indicator
• Right turn signal indicator
• Run or start
• S106
• Seat belt indicator lamp
• Seat belt indicator lamp control
• Seat belt switch (left b-pillar)
• Speedometer
• Speedometer control
• Tachometer
• Tachometer control
• Transmission system (autostick switch)
• Vehicle theft security system (vtss) set l.e.d.

Instrument Cluster Wiring Diagram (2 of 2) for Chrysler Cirrus LXi 1999

List of elements for Instrument Cluster Wiring Diagram (2 of 2) for Chrysler Cirrus LXi 1999:

34

• (eng harn, in pdc) s110
• (eng narn, near breakout to pcm connector)
• A/t
• Acc
• Air bag control module (under floor console, behind selector)
• Body control module
• Brake warning pressure switch (on master cylinder)
• Ccd bus (+)
• Ccd bus (-)
• Controller anti-lock brake (right front of engine compartment)
• Daytime running lamps module (canadian models)
• Fuel level sensor
• Fuel level sensor signal
• Fuel pump module (in center rear of trunk)
• G102 (left front strut tower)
• G407 (below trunk lid opening, below latch)
• Ignition switch
• Junction block (under left side of dash)
• Lock
• M/t
• Off
• Oil pressure switch (2.0 & 2.4l: right front side of engine) (2.5l: left side of engine)
• Park brake switch (on park brake lever)
• Powertrain control module (left fender shield)
• Run
• S101
• S130
• Seat belt switch sense
• Sensor return
• Start
• Transmission control module (left fender side shield)
• Vehicle speed sensor (left rear of transmission)
• Vss signal
• Vtss indicator lamp driver