CRUISE CONTROL
Cruise Control Wiring Diagram for Chrysler PT Cruiser Limited 2002
List of elements for Cruise Control Wiring Diagram for Chrysler PT Cruiser Limited 2002:
- on/off
- (below steering column)
- (center rear of dash) g200
- (cruise)
- (left side of engine)
- (near breakout to engine oil pressure switch)
- (near datalink connector)
- (under left side of dash) datalink connector
- +8v
- A/t
- Brake lamp switch
- Cancel
- Clock- spring
- Computer data lines system
- Cruise
- Dump
- Fuse 10 10a
- Fuse block (lower left front of dash)
- Fused ignition
- G104 (front of right front fender)
- Ground
- Hot in run or start
- Instrument cluster
- M/t
- Pci bus
- Pnk
- Powertrain control module (on firewall, behind power distribution center)
- Red/ tan
- Res/accel
- S107
- S109
- S121
- S126
- S139 (near breakout to left foglamp)
- S201
- S239
- Sci receive
- Sci transmit
- Sensor gnd
- Set/coast
- Speed control servo (right rear of engine compt)
- Speed signal
- Speed sw sig
- Tan/red
- Transmission control module (left front of engine compt)
- Vacuum
- Vacuum sol
- Vehicle speed control switch
- Vehicle speed sensor (m/t) (right rear side of transaxle)
- Vent
- Vent sol
- Vf display
- Vss input