ANTI-LOCK BRAKES – Dodge Durango R/T 2002 – SYSTEM WIRING DIAGRAMS

ANTI-LOCK BRAKES

Anti-lock Brake Wiring Diagrams for Dodge Durango R/T 2002

List of elements for Anti-lock Brake Wiring Diagrams for Dodge Durango R/T 2002:

• (under dash, left of steering column)
• A10
• A20
• B10
• B113
• B114
• Brake fluid level switch (in brake system combination valve)
• Brake lamp sw sense
• Brake lamp switch (on brake pedal support)
• Brake pressure switch
• Controller anti-lock brake (mounted on top of hydraulic control unit)
• D25
• Data link connector
• Diagnostic junction port (under left side of dash)
• Forward of washer fluid reservoir)
• Fuse 10a
• Fuse 40a
• Fuse b (+)
• Fuse ignition sw (run)
• G113 (near battery)
• G207 (lower center of dash)
• Ground
• Hot at all times
• Hot in run
• Joint connector 2 (in power ditribution center)
• Jtec
• Junction block (on left end of dash)
• Left front wheel speed sensor (w/ all wheel abs) (on left front steering knuckle)
• Lf whl spd sensor (+)
• Lf whl spd sensor (-)
• Ngc
• On radiator core support)
• Pci bus
• Power distribution center (on left inner fender)
• Powertrain control module (on right front inner fender,
• Rear wheel sensor (+)
• Rear wheel sensor (-)
• Rear wheel speed sensor (on top of differential housing)
• Red
• Rf whl spd sensor (+)
• Rf whl spd sensor (-)
• Right front wheel speed sensor (w/ all wheel abs) (on right front steering knuckle)
• S124 (left rear of eng compt)
• S126
• S174 (near powertrain control module)
• S206 (near diagnostic junction block)
• Sci transmit
• Shift interlock system
• Stoplight sw sense signal
• Transmission control module (on right front of engine compt,
• V40
• Vehicle speed sig
• Vehicle speed signal
• W/ 4.7l (jtec) only
• W/ 4.7l only
• W/ all wheel abs
• Z19