ANTI-LOCK BRAKES – Dodge Neon SXT 2002 – SYSTEM WIRING DIAGRAMS

ANTI-LOCK BRAKES

Anti-lock Brake Wiring Diagrams for Dodge Neon SXT 2002

List of elements for Anti-lock Brake Wiring Diagrams for Dodge Neon SXT 2002:

• (near a/c low pressure switch breakout)
• 1.6l only
• A10
• A20
• B27
• Brake lamp switch (top of brake pedal support)
• Brake lmp sw
• Controller anti-lock brake (below master cylinder)
• D25
• Data link connector (at left side of steering column)
• Exterior lights system
• F12
• Fuse 10 15a
• Fuse 23 15a
• Fuse 5 30a
• Fuse 8 40a
• Fuse block (on left side of dash)
• Fused b (+) (pump)
• Fused b (+) (valve)
• G102 (left front of eng compt)
• G203 (lower center of dash)
• Ground
• Hot at all times
• Hot in run or start
• Ign sw (start/run)
• Instrument cluster system
• L50
• Left front wheel speed sensor (on left steering knuckle)
• Left rear wheel speed sensor (attached to left disc brake adapter)
• Lf whl sens (12v)
• Lf whl sens sig
• Lr whl sens (12v)
• Lr whl sens sig
• Panel lamps driver
• Pci bus
• Power distribution center (on left side of engine compt, near battery)
• Red
• Rf whl sens (12v)
• Rf whl sens sig
• Right front wheel speed sensor (on right steering knuckle)
• Right rear wheel speed sensor (attached to right disc brake adapter)
• Rr whl sens (12v)
• Rr whl sens sig
• S104 (eng harn, near breakout for data link connector)
• S108
• S109
• S112
• S202
• Trac cntrl sw
• Trac cntrl sw sig
• Traction control switch