TRANSMISSION
3.8L VIN K
3.8L VIN K, A/T Wiring Diagram for Buick LeSabre Custom 2005
List of elements for 3.8L VIN K, A/T Wiring Diagram for Buick LeSabre Custom 2005:
- (bonneville: on right front of transaxle, below power steering pump) (lesabre: on top right side of transmission output housing) vehicle speed sensor (vss)
- (lesabre) s212 s208 (bonneville)
- (on rear of engine, near thermostat housing) engine coolant temperature (ect) sensor
- 1-2 shift sol
- 2-3 shift sol
- 5 volt ref
- A/t fluid temp
- A/t iss low
- A/t speed sens
- Acc
- Automatic transaxle
- Automatic transaxle fluid temperature sensor
- Automatic transaxle input shaft speed sensor
- Automatic transaxle internal mode switch
- Automatic transmission fluid pressure manual valve position switch
- B c
- Battery
- Bonneville
- Bonneville le sabre
- Computer data lines system
- Cruise control system
- E e
- Ect sensor in
- Engine controls system
- G105
- Hot at all times
- Hot in run or start
- Ign
- Ign 1
- Ign 1 fuse 10a
- Ign-1 fuse 10a
- Ignition
- Ignition 1
- Ignition switch
- Instrument cluster
- Le sabre
- Lock
- Logic
- Malfunc-
- Malfunction indicator lamp
- Map sensor gnd
- Mil control
- Off
- Pcm batt fuse 10a
- Pcm ground
- Pcm ign fuse 10a
- Pnk
- Powertrain control module (pcm) (near air cleaner housing)
- Press sol high
- Press sol low
- Pressure control sol
- Rear fuse block (under left rear seat)
- Red
- Run
- S109
- S216
- Sensor return
- Serial data
- Shift sol a
- Shift sol b
- Sp105 (bonneville: below ignition control module)
- Start
- Stop lamp switch (lesabre: on brake pedal bracket) (bonneville: lower left side of dash)
- Tcc pwm sol
- Tcc rel switch
- Tcc release sw
- Tcc sw
- Tcc/ cruise switch
- Throttle position (tp) sensor (on throttle body assembly)
- Tion ind lamp
- Tp sensor gnd
- Tp sensor in
- Trans fuse 10a
- Trans sw a
- Trans sw b
- Trans sw c
- Trans sw p
- Under- hood fuse block (right front side of engine compt)
- Vss hi (signal)
- Vss lo (ground)