STARTING/CHARGING – Audi Q5 2010 – SYSTEM WIRING DIAGRAMS

STARTING/CHARGING

Charging Wiring Diagram for Audi Q5 2010

List of elements for Charging Wiring Diagram for Audi Q5 2010:

• Battery
• Battery interrupt igniter
• Battery jump start terminal
• Battery monitoring control module
• Computer data lines system
• Data bus on board diagnostic interface
• Fuse panel sa
• G624 (in luggage compt near starter battery)
• Generator & voltage regulator
• Instrument cluster control module
• Starter
• T2y

Starting Wiring Diagram for Audi Q5 2010

List of elements for Starting Wiring Diagram for Audi Q5 2010:

• (on transmission) transmission control module (tcm)
• 10a
• Battery
• Battery interrupt igniter
• Battery jump start terminal
• Battery monitoring control module
• Charging circuit
• Clutch position sensor (m/t)
• Comfort system central control module (left side of trunk)
• Computer data lines system
• Direct shift gearbox (dsg) mechatronic (on transmission)
• Engine control module (ecm) (in plenum chamber driver's side)
• Fuse 110a
• Fuse 3 5a
• Fuse 5a
• Fuse carrier 1
• Fuse panel sa
• Fuse panel sc
• G624 (in luggage compt near starter battery)
• G639 (behind left lower "a" pillar)
• G688 (on right side of center tunnel)
• Prnds
• Red
• Relay/ fuse panel sb (driver's side plenum chamber on electronics box)
• Selector lever sensor system control module
• Starter
• Starter relay (relay/fuse panel b)
• Starter relay 2 (relay/fuse panel b)
• Steering column electronic systems control module (on steering column)
• T16f
• T16r
• T2y
• T32d
• T94
• Transmission control module (tcm)
• W/ direct shift
• W/o direct shift