ANTI-LOCK BRAKES – Jeep Liberty Sport 2002 – SYSTEM WIRING DIAGRAMS

ANTI-LOCK BRAKES

Anti-lock Brake Wiring Diagrams for Jeep Liberty Sport 2002

List of elements for Anti-lock Brake Wiring Diagrams for Jeep Liberty Sport 2002:

• (near breakout to power distribution center)
• A10
• A20
• Abs warning ind control
• Abs warning indicator
• B12
• Body control module (on junction block, under left side of dash)
• Brake lamp sw
• Brake lamp switch (top of brake pedal)
• Brake pressure switch (on master cylinder)
• C201
• Controller anti-lock brake (left rear of eng compt)
• D24
• D25
• Data link connector (under center of dash)
• Diagnostic junction port (under center of dash)
• F22
• Flash abs
• Fluid press sw sig
• Fuse 10a
• Fuse 15a
• Fuse 20a
• Fuse 40a
• Fuse b (+)
• Fuse ign sw (run)
• G110 (left side of eng compt)
• Ground
• Hot at all times
• Instrument cluster
• Jucntion block center (under left side of dash)
• L50
• Left front wheel speed sensor (attached to left knuckle boss)
• Lf whl spd 12v
• Lf whl spd sign
• Not used
• Pci bus
• Pnk
• Power distribution center (on left side of eng compt)
• Rear wheel speed sensor (on center rear axle assembly)
• Rear whl spd 12v
• Rear whl spd sign
• Red
• Rf whl spd 12v
• Rf whl spd sign
• Right front wheel speed sensor (attached to right knuckle boss)
• S112
• S122
• S207 (near breakout to c100, gray connector at left kick panel)
• S43
• Transmission control module
• Vehicle speed sig
• Z101
• Z102