CRUISE CONTROL – Jeep Commander Overland 2008 – SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

Cruise Control Wiring Diagram for Jeep Commander Overland 2008

List of elements for Cruise Control Wiring Diagram for Jeep Commander Overland 2008:

• (3.7l: right rear of engine compt) (4.7l/5.7l: rear of engine) s140
• (left rear of engine compt)
• 3.7l/5.7l
• 4.7l
• A108
• Accelerator pedal position sensor (base of accelerator pedal)
• Apps 1 sens gnd
• Apps 1 sig
• Apps 2 sens gnd
• Apps 2 sig
• B15
• B16
• Brake sw 1 sig
• Brake sw 2 sig
• Etc motor (+)
• Etc motor (-)
• F855
• F856
• Fuse 10a
• Fused b (+)
• G100
• G200
• Ground
• Hot at all times
• Hot in run or start
• Input speed sensor (except 3.7l) (left side of transmission)
• Junction block (left side of dash)
• K122
• K124
• K126
• K167
• K22
• K23
• K29
• K400
• K922
• Left speed control switch
• Output speed sensor (except 3.7l) (left side of transmission)
• Powertrain control module (right rear of engine compt)
• Right speed control switch
• S/c sw rtn
• S/c sw sense 1
• S/c sw sense 2
• S/c sw sig 1
• S/c sw sig 2
• S101
• S106
• S139 (4.7l: right rear of engine) (3.7l: rear of engine) (5.7l: right rear of engine compt)
• S144 (front of transmission)
• S200
• S201
• S212
• S218
• S228
• Sens gnd
• Speed sens sig
• Steering control module (in steering wheel)
• Stop lamp switch (lower left side of dash)
• T13
• T14
• T52
• Throttle body (top front of engine)
• Tp 1 sig
• Tp 2 sig
• Tp sensor rtn
• V371
• V372
• V397
• V71
• V72
• V937
• Z907