WARNING SYSTEMS
Warning Systems Wiring Diagram for Cadillac XLR 2005
List of elements for Warning Systems Wiring Diagram for Cadillac XLR 2005:
- Ajar
- Audible alarm
- Auto
- Bcm class 2 serial data
- Bcm high spd gmlan serial data bus +
- Bcm high spd gmlan serial data bus -
- Body control module (bcm) (behind right side of dash)
- C1 a5
- Class 2 (rcdlr)
- Class 2 (sdm)
- Closed
- Computer data lines system
- Driver door latch
- Ecm high spd gmlan serial data bus +
- Ecm high spd gmlan serial data bus -
- Engine control module (ecm) (behind lower right front fender)
- G201
- G301
- Head
- Inflatable restraint sensing & diagnostic module (sdm) (located underneath vehicle console)
- Instrument panel cluster (ipc)
- Internal antenna
- Ipc
- Ipc class 2 serial data
- Left front tire pressure monitor
- Left rear tire pressure monitor
- Left seat belt sw
- Left seat belt switch
- Lf dr open sw sig
- Lf turn sig sw
- Logic
- Low ref
- Low tire pressure ind
- Message center
- Message request
- Off
- Open
- Park
- Pk lmp sw on sig
- Pnk
- Remote control door lock receiver (rcdlr) (right side of dash)
- Rf turn sig sw
- Rfa class 2 serial data
- Right front tire pressure monitor
- Right rear tire pressure monitor
- S275
- S375
- S391 (in rear body harness, approximately 6.5 cm (2.5 in) from passenger turn signal breakout)
- Sdm class 2 serial data
- Seat belt ind
- Solid state
- Sp201 (in instrument panel harness, in passengers compartment, at base of left "a" pillar behind trim panel)
- Sp301 (in instrument panel harness, in passengers compartment, on left "b" pillar behind trim panel)
- Tan
- Turn signal/ multifunction switch