CRUISE CONTROL
Cruise Control Wiring Diagram for Lincoln Navigator 1998
List of elements for Cruise Control Wiring Diagram for Lincoln Navigator 1998:
- 15a
- 20a
- Accel
- Brake pedal position (bpp) switch (under left side of dash)
- Brake press in
- Brake pressure switch (left rear corner of engine compt)
- C234
- C242
- C257
- Clock- spring assembly (top of steering column)
- Coast
- Control sw gnd
- Control sw in
- Fuse 13
- Fuse 5
- G105 (rear of right fender apron)
- G200 (lower left inner kick panel)
- Ground
- Horn relay (in power distribution box)
- Horn switch
- Hot at all times
- Hot in run
- Ign
- Interior lights system
- Junction box fuse/relay panel
- Nca
- Off
- Ohms
- Power distri- bution box
- Redundant steering control module
- Remote anti-theft personality (rap) module (behind left side of dash)
- Resume
- S102
- S107
- S112
- S143 (engine sensor harn, near breakout to windshield wiper motor)
- S144 (engine sensor harn, left rear of engine compt)
- S218 (main body harness, near breakout to redundant steering control module)
- Set/
- Speed control servo/ amplifier assembly (in left rear of engine compt)
- Speed control switch assembly
- Vehicle speed input
- Vehicle speed sensor (vss) (left rear of trans)