AUTOMOTIVE ELECTRICIANS PORTAL
WIRING-DIAGRAMS

CRUISE CONTROL – Ford Aerostar 1994 – SYSTEM WIRING DIAGRAMS

  1. Home
  2. >FORD
  3. >Ford 1994
  4. >Ford Aerostar 1994
  5. >Ford Aerostar 1994 - ALL WIRING DIAGRAMS

Download PDF file

CRUISE CONTROL

3.0L

3.0L, Cruise Control Wiring Diagram for Ford Aerostar 1994

3.0L, Cruise Control Wiring Diagram for Ford Aerostar 1994Download PDF file

List of elements for 3.0L, Cruise Control Wiring Diagram for Ford Aerostar 1994:

  • (below center of instrument
  • (front of left fender apron,
  • (in steering wheel)
  • (left rear corner of engine compartment)
  • (on brake pedal support)
  • (on clutch pedal support)
  • 100-
  • 40-
  • 50,000 ohms
  • A/t
  • Accel
  • Actuator (connects to throttle linkage)
  • Analog digital
  • Battery
  • Brake input
  • Brake on/off (boo) switch
  • C249 (analog)
  • C254 (digital)
  • Clock- spring assembly (inside steering column)
  • Clutch pedal position (cpp) switch
  • Cntl sw input
  • Coast
  • Cruise control amplifier (right side of instrument panel, above cowl panel)
  • Cruise control servo
  • Cruise control switch assembly (partial)
  • Exterior lights system (multi-function switch)
  • Fast
  • Fuse 1 15a
  • Fuse 17 10a
  • Fuse 2 30a
  • Fuse 6 20a
  • Fuse 8 15a
  • Fuse panel
  • G100
  • G206
  • Gnd
  • Ground
  • Horn relay (right side of steering column)
  • Horns system
  • Horns system
  • Hot at all times
  • Hot in accy or run
  • Hot in run
  • Ignition
  • Instrument cluster
  • Left of battery)
  • M/t
  • Nca
  • Off
  • Ohms
  • Panel, below right side of radio)
  • Pnk/
  • Psom module
  • Red
  • Red/
  • Resume
  • Run
  • Servo motor
  • Servo posit feed
  • Servo posit gnd
  • Servo posit signal
  • Set/
  • Slow
  • Sol volt source
  • Sol+
  • Speed output
  • Speed input
  • Vac
  • Vac sol cntl
  • Vacuum distribution
  • Vacuum dump valve (vents to atmosphere when brake is depressed)
  • Vent
  • Vent sol cntl

4.0L

4.0L, Cruise Control Wiring Diagram for Ford Aerostar 1994

4.0L, Cruise Control Wiring Diagram for Ford Aerostar 1994Get access to all wiring diagrams of the carDownload PDF file

List of elements for 4.0L, Cruise Control Wiring Diagram for Ford Aerostar 1994:

  • (below center of instrument
  • (front of left fender apron,
  • (in steering wheel)
  • (left rear corner of engine compartment)
  • (on brake pedal support)
  • (on clutch pedal support)
  • 100-
  • 40-
  • 50,000 ohms
  • A/t
  • Accel
  • Actuator (connects to throttle linkage)
  • Analog digital
  • Battery
  • Brake input
  • Brake on/off (boo) switch
  • C249 (analog)
  • C254 (digital)
  • Clock- spring assembly (inside steering column)
  • Clutch pedal position (cpp) switch
  • Cntl sw input
  • Coast
  • Cruise control amplifier (right side of instrument panel, above cowl panel)
  • Cruise control servo
  • Cruise control switch assembly (partial)
  • Exterior lights system (multi-function switch)
  • Fast
  • Fuse 1 15a
  • Fuse 17 10a
  • Fuse 2 30a
  • Fuse 6 20a
  • Fuse 8 15a
  • Fuse panel
  • G100
  • G206
  • Gnd
  • Ground
  • Horn relay (right side of steering column)
  • Horns system
  • Horns system
  • Hot at all times
  • Hot in accy or run
  • Hot in run
  • Ignition
  • Instrument cluster
  • Left of battery)
  • M/t
  • Nca
  • Off
  • Ohms
  • Panel, below right side of radio)
  • Pnk/
  • Psom module
  • Red
  • Red/
  • Resume
  • Run
  • Servo motor
  • Servo posit feed
  • Servo posit gnd
  • Servo posit signal
  • Set/
  • Slow
  • Sol volt source
  • Sol+
  • Speed output
  • Speed input
  • Vac
  • Vac sol cntl
  • Vacuum distribution
  • Vacuum dump valve (vents to atmosphere when brake is depressed)
  • Vent
  • Vent sol cntl