ELECTRONIC SUSPENSION – Ford Crown Victoria LX 2010 – SYSTEM WIRING DIAGRAMS

ELECTRONIC SUSPENSION

Electronic Suspension Wiring Diagram for Ford Crown Victoria LX 2010

List of elements for Electronic Suspension Wiring Diagram for Ford Crown Victoria LX 2010:

• (body main wiring harness, near breakout to c423) s450
• (dash panel to headlight junction harness, near breakout to battery junction box)
• (dash panel to headlight junction harness, near breakout to powertrain control module) s113
• (right side of engine compt) battery junction box (bjb)
• (under rear of vehicle, attached to control arm) air suspension height sensor
• Air suspension compressor assembly (left front side of engine compt)
• Air suspension compressor relay
• Air suspension disable switch (left side of luggage compt)
• Backht a
• Batt
• Battery junction box (bjb) (right side of engine compt)
• C2131a
• C2131b
• Central junction box (cjb) (under left side of dash)
• Compressor
• Computer data lines system
• Fuse 10a
• Fusible link 112 30a
• G102 (front of left fender)
• G109 (front of right fender)
• G405 (behind center of rear seat)
• Gnd
• Hot at all times
• Hot in run
• Hs can+
• Hs can-
• Ht sens pwr
• Left rear air spring solenoid valve (under left rear of vehicle)
• Lh sol
• Nca
• On/off sw
• Pnk
• Return
• Rh sol
• Right rear air spring solenoid valve (under right rear of vehicle)
• S112 (dash panel to headlight junction harness, near breakout to c1010)
• S121
• S490 (main body wiring harness, near breakout to fuel pump driver module)
• Sw ign
• Vehicle dynamics module (vdm)
• Vent
• Vpwr