TRANSMISSION
Transmission Wiring Diagram, 4L60-E for Oldsmobile Bravada 1993
List of elements for Transmission Wiring Diagram, 4L60-E for Oldsmobile Bravada 1993:
- "high"
- "low"
- (pcm)
- (behind left side of i/p)
- (behind lh side of i/p)
- (behind right side of i/p)
- (behind right side of i/p, near pcm)
- (below left i/p, right of steering column)
- (front of engine)
- (left rear of transmission)
- (on brake pedal support bracket)
- (rear of left
- (rear of left cylinder head)
- (top left front of engine)
- (under left side of i/p, left of steering column)
- 1-2 shift sol
- 1-2 shift sol signal
- 1993 model
- 1994 model
- 2-3 shift sol
- 2-3 shift sol signal
- 3-2 control sol
- 5 volt reference
- A14
- A15
- B10
- Battery feed
- Brake fuse 15a
- Brake signal
- C11
- C12
- C13
- Conn 1
- Conn 2
- Cruise control module
- Cruise signal
- Cylinder head)
- Data link connector (partial)
- Diagnostic test
- Diode module
- E10
- E13
- E15
- E16
- Ecmb fuse 15a
- Ecmi fuse 10a
- Ect signal
- Electronic 4 - speed overdrive transmission (rear of engine)
- Engine coolant temperature sensor
- F10
- F12
- F13
- F14
- Fluid press switch assembly
- Force motor
- G114
- Hot at all times
- Hot in run
- Hot in run, bulb
- I/p fuse block
- Ign/gau fuse 20a
- Ignition feed
- Map ground
- Pnk
- Powertrain control module
- Range signal "a"
- Range signal "b"
- Range signal "c"
- Red
- Sensor ground
- Serial data
- System gnd
- Tcc sol
- Tcc/brake switch
- Test or start
- Tft fluid signal
- Throttle position sensor
- Tp signal
- Trans output speed vehicle speed signal
- Trans- mission fluid temp sensor
- Vehicle speed sensor
- Vehicle speed sensor buffer