CRUISE CONTROL – Pontiac Trans Sport Montana 1998 – SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

Cruise Control Wiring Diagram for Pontiac Trans Sport Montana 1998

List of elements for Cruise Control Wiring Diagram for Pontiac Trans Sport Montana 1998:

• (i/p harn, 6 cm from hazard lamp/turn signal switch breakout)
• (left side of engine compt)
• 4000 pulses/mile
• All times
• B10
• Cruise control module
• Cruise control release switch (top of pedal support)
• Cruise control switch
• Cruise fuse 10a
• Cruise inhibit
• Cruise inhibit input
• Cruise on input
• Cruise status
• D10
• Disengage input
• Fuse block
• G202 (left side of dash, on under- side of cross-car beam)
• Ground
• Hot at
• Hot in run, bulb
• Ignition
• Nca
• Off
• Pnk
• Powertrain control module (pcm) (left front of engine compt)
• R/a
• Resume/accel input
• S205
• S266
• Set sw
• Set/coast input
• Stop lamp fuse 15a
• Stop lamp switch (top of brake pedal support)
• Test or start
• Underhood electrical center
• Vehicle speed input
• Vehicle speed sensor (vss) (right side of transaxle)
• Vss return
• Vss signal