TRANSMISSION – Pontiac G3 2009 – SYSTEM WIRING DIAGRAMS

TRANSMISSION

Transmission Wiring Diagram for Pontiac G3 2009

List of elements for Transmission Wiring Diagram for Pontiac G3 2009:

• wake up sig
• (next to starter) g104
• Automatic transmission
• Automatic transmission input shaft speed (iss) sensor
• Computer data lines system
• Ecu ef14 fuse 10a
• Ems2 fuse f5 10a
• Engine control module (ecm) (left front fender, near the battery)
• Exterior lights system
• G104 (next to starter)
• Gnd
• Hot at all times
• Hot in acc or run
• I/p fuse block (left side of dash, in door opening)
• Ign 1
• Ign lck act sig
• Instrument panel cluster (ipc)
• Iss sens hi sig
• Iss sens low sig
• J102
• J223 (i/p harness, near breakout to g201)
• Logic
• Low ref
• Park/ neutral
• Park/neutral position (pnp) switch (side of transaxle)
• Pcs ctrl
• Pnk
• Pnp sw neutral
• Pressure control solenoid valve
• Reverse
• Sdl sply volt
• Ser data hi
• Ser data low
• Shift sol 1
• Shift sol 2
• Shift solenoid 1 valve
• Shift solenoid 2 valve
• Signal a
• Signal b
• Signal c
• Speedometer
• Starting/ charging system
• Stop lamp fuse f7 15a
• Stop lamp switch (brake pedal assembly)
• Stop lp sply volt
• Tcc sol ctrl
• Tcc solenoid valve
• Tft sens ref
• Tft sens sig
• Tft sensor
• Timing solenoid valve
• Timing vlv
• Transmission control module (tcm)
• Underhood fuse block (left side of engine compt)
• Vehicle speed sensor (vss) (right rear of engine)
• Vss sig
• Wake up sig