ANTI-THEFT – Saturn Ion 2 2007 – SYSTEM WIRING DIAGRAMS

ANTI-THEFT

Anti-theft Wiring Diagram for Saturn Ion 2 2007

List of elements for Anti-theft Wiring Diagram for Saturn Ion 2 2007:

• (2.0l: at rear of engine, near coolant overflow container) (2.2l & 2.4l: at left side of engine compt) (2.0l) powertrain control module (pcm) (2.2l & 2.4l) engine control module (ecm)
• (in body harness, 7.5 cm from rear compartment light breakout) s413
• (near front left passenger seat belt)
• 2.0l
• 2.2l & 2.4l
• 2.4l & 2.2l
• 5v ref
• Acc
• Ajar switch
• B(+)
• Bcm (pwr) fuse 15a
• Bcm class 2 serial data
• Bcm elect fuse 20a
• Body control module (bcm) (at lower center of dash)
• Cluster/ aos fuse 7.5a
• Dash fuse 7.5a
• Driver door jamb switch (behind left i/p access panel)
• Driver door jamb switch signal
• Ecm class 2 serial data
• Engine controls system
• Exterior lights system
• Front passenger door jamb switch (right front of dash, on outer trim cover)
• Fuel injector control
• G201 (behind lower left side of dash, left of steering column)
• G301 (under driver's seat)
• G403 (under center of rear shelf)
• Gnd
• Horn relay ctrl
• Horns system
• Hot at all times
• Ignition switch
• Instrument panel cluster
• Interior lights system
• Left rear door jamb switch (sedan) (in right "b" pillar)
• Logic
• Nca
• Off
• Off/ run/ crank volt
• Passenger door jamb switch signal
• Rear compartment lid latch (in rear compartment lid)
• Right rear door jamb switch (sedan)
• Run
• S221
• S250
• S351
• S990
• Security indicator
• Security indicator control
• Start
• Trunk ajar switch signal
• Turn/ hazard switch power