STARTING/CHARGING – Saturn Ion Red Line 2006 – SYSTEM WIRING DIAGRAMS

STARTING/CHARGING

Charging Wiring Diagram for Saturn Ion Red Line 2006

List of elements for Charging Wiring Diagram for Saturn Ion Red Line 2006:

• (in engine harness, 5 cm from engine harness breakout)
• (or rust)
• 2.0l
• 2.2l
• 2.4l
• Battery
• Body control module (bcm) (at lower center of dash)
• Charge indicator
• Cluster/aos fuse 7.5a
• Cycle sig
• Engine control module (ecm) (2.2l & 2.4l) powertrain control module (pcm) (2.0l) (2.2l & 2.4l: at left side of engine compartment) (2.0l: at rear of engine, near coolant overflow container)
• G201 (behind lower left side of dash, left of steering column)
• G502 (at right rear side of trunk)
• Gen field duty
• Gen turn on sig
• Generator
• Gnd
• Hot at all times
• Instrument panel cluster (ipc)
• Logic
• Power distribution system
• Red
• S150
• S250
• Serial data (class 2)
• Starter
• Underhood fuse block (at left rear side of engine compt)

Starting Wiring Diagram for Saturn Ion Red Line 2006

List of elements for Starting Wiring Diagram for Saturn Ion Red Line 2006:

• (at left rear side of engine compartment) underhood fuse block
• 5v ref
• Acc
• Armature m
• B10
• Battery
• Bcm class 2 serial data
• Body control module (bcm) (at lower center of dash)
• Charging circuit
• Clutch start switch (below left side of dash, on clutch pedal bracket)
• Clutch start switch signal
• Clutch/ brake/aos fuse 7.5a
• Crank fuse 46 30a
• Ecm class 2 serial data
• G502 (at right rear side of trunk)
• Hold-in windings
• Hot in acc or run
• Ignition switch
• Logic
• Off
• Off/run/crank voltage
• Pcm cont relay 31
• Pnk
• Powertrain control module (pcm) (at rear of engine, near coolant overflow container)
• Pull-in windings
• Red
• Run
• Start
• Starter
• Starter relay coil control