TRANSMISSION
Transmission Wiring Diagram for Nissan 240SX SE 1995
List of elements for Transmission Wiring Diagram for Nissan 240SX SE 1995:
- 1995 vftc c
- A/t control unit (behind left side of dash)
- A/t fluid temperature sensor
- All times
- Ascd control unit (behind right kick panel)
- Atck
- Automatic transmission
- Avcc
- Closed
- Cruise
- Data link connector (for consult) (below left side of i/p)
- Dropping resistor (left side of engine compt)
- Dt1
- Dt2
- Dt3
- Eccs control module (behind right kick panel)
- Engine coolant temperature sensor (front corner of intake manifold)
- Fuse 7.5a
- Fuse block (left kick panel)
- G114 (left rear of engine)
- G200 (left kick panel)
- G300 (below left front seat)
- Gnd a
- Hot at
- Hot in on or start
- Ind.
- Inhibitor switch (right side of transmission)
- Instrument cluster
- Kickdown switch (1995) (on bracket, above accelerator pedal)
- Line pressure solenoid valve
- Nca
- Neut
- O.d. off ind
- Overdrive switch
- Overrun clutch solenoid
- Pnk
- Red
- Revolution sensor
- Shift solenoid valve a
- Shift solenoid valve b
- Speedometer
- Tacho
- Throttle position sensor (on throttle body)
- Throttle position switch (on throttle body)
- Torque converter clutch solenoid valve
- Tv01
- Tvoo
- Vehicle speed sensor (on trans- mission tail shaft)
- Wide open