CRUISE CONTROL – Chevrolet TrailBlazer 2009 – SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

Cruise Control Wiring Diagram for Chevrolet TrailBlazer 2009

List of elements for Cruise Control Wiring Diagram for Chevrolet TrailBlazer 2009:

• (in engine harness, 10 cm from breakout to x107) j105
• 5 volt ref
• Accelerator pedal position (app) sensor
• App sensor 1
• App sensor 2
• B10
• B4 x1
• C9 x2
• Cruise ind
• Cruise release
• E3 x3
• Electronic brake control module (ebcm) (on inner left frame rail, beside transmission)
• Engine control module (lower left front of engine)
• Exterior lights system
• G108 (on lower left side of engine)
• Gnd
• Hot at all times
• Hot in run
• Hot in run or start
• Hvac i fuse 39 10a
• Ign
• Ign e fuse 22 10a
• Instrument panel cluster (ipc)
• Ipc class 2 serial data
• J101
• J239
• Logic
• Low ref
• Nca
• On sw
• On/off switch
• Pnk
• Power distribution system
• Rear fuse block (below left rear seat)
• Res+
• Res/accel sw
• Serial data
• Serial data bus +
• Serial data bus -
• Set-
• Set/coast sw
• Splice pack jx205 (behind left of dash, near headlamp switch connector)
• Stop lamp fuse 12 25a
• Stop lamp in
• Stop lamp switch (on brake pedal assembly)
• Tac motor ctrl 1
• Tac motor ctrl 2
• Tan
• Throttle body (front of intake duct)
• Tp sensor 1
• Tp sensor 2
• Transmission control module (tcm) (left front of engine compt)
• Turn signal/ multi-function switch
• Underhood fuse block (above left front wheelwell)
• Veh stop fuse 34 15a
• Vehicle speed sensor (vss) (inside automatic transmission assembly)
• Vss hi
• Vss lo