STARTING/CHARGING – Chevrolet Metro LSi 2000 – SYSTEM WIRING DIAGRAMS

STARTING/CHARGING

Charging Wiring Diagram for Chevrolet Metro LSi 2000

List of elements for Charging Wiring Diagram for Chevrolet Metro LSi 2000:

• (engine harness, approximately 10 cm (4 in) from grommet center of engine compartment on bulkhead) s162
• (engine harness, approximately 8 cm (3.1 in) from grommet center of engine compartment on bulkhead) s126 (vin 6) s160 (vin 2) (engine harness, approximately 20 cm (8 in) from grommet center of engine compartment on bulkhead)
• Acc
• Bat
• Batt fuse 70a
• Battery
• C7 junction block (on left side of dash)
• Charge indicator
• Daytime running lamps (drl) control module (behind left side of dash)
• Fuse box (on left side of engine compartment, behind battery)
• G108 (left front of engine compartment, front of battery)
• G130 (mounted on top left side of transaxle)
• Generator
• Ig fuse 60a
• Ig-coil fuse 15a
• Ignition switch
• Instrument panel cluster assembly
• Junction block (on left side of dash)
• Lock
• Red
• S242 (dash harness, at breakout of i/p cluster assembly connector c3)
• Start
• Starter solenoid

Starting Wiring Diagram for Chevrolet Metro LSi 2000

List of elements for Starting Wiring Diagram for Chevrolet Metro LSi 2000:

• (left front of engine compartment, front of battery) g108
• (mounted on top left side of transaxle) g130
• A/t
• Acc
• Batt fuse 70a
• Battery
• Clutch pedal position (cpp) switch (above clutch pedal)
• Engine controls system
• Fuse box (on left side of engine compartment, behind battery)
• Hold-in winding
• Ig fuse 60a
• Ignition switch
• Junction block (on left side of dash)
• Lock
• M/t
• Nca
• Pull-in winding
• S127 (m/t only) (engine harness, at generator breakout)
• Start
• Starter motor
• Starter solenoid
• Transaxle range switch (top of transaxle)