WARNING SYSTEMS – Chevrolet Camaro Z/28 2014 – SYSTEM WIRING DIAGRAMS

WARNING SYSTEMS

Warning Systems Wiring Diagram for Chevrolet Camaro Z/28 2014

List of elements for Warning Systems Wiring Diagram for Chevrolet Camaro Z/28 2014:

• (body harness, 17.8 cm from breakout to x307) j303
• (driver door harness, 3.2 cm from breakout to x501) j504
• (master cylinder reservoir) brake fluid level switch
• (on right front strut tower) electronic brake control module (ebcm)
• Acc
• Ajar sw sig
• Auto
• Bcm 6 fuse 20a
• Body control module (left side of dash)
• Brake ind
• Bus 3
• Computer data lines system
• Dlis fuse 5a
• Driver door latch assembly
• Driver information center display
• Driver seat belt buckle (right rear side of driver's seat)
• Driver seat belt switch
• Driver window motor
• Driver window switch
• G102 (lower right side of engine compt)
• G201 (left kick panel)
• G203 (under left front of center console)
• G205 (left kick panel)
• G206 (right kick panel)
• Gmlan serial data
• Ground
• Head
• Headlamp sw prk lamp sig
• Headlamp switch
• Hi spd gmlan ser data bus +
• Hi spd gmlan ser data bus -
• Hot at all times
• Ign volt
• Ignition switch
• Inflatable restraint sensing & diagnostic module (under rear of center console)
• Instrument cluster
• Instrument panel fuse block (left end of dash)
• J312 (driver seat harness, 5 cm from breakout to x307)
• J500
• J600
• Key ignition switch
• Lo spd gmlan serial data
• Logic
• Low tire pressure ind
• Lvl sens sig
• Nca
• Network
• Network 3
• Network bus 3
• Off
• Park
• Park brake switch (base of park brake lever assembly)
• Passenger door latch assembly
• Passenger window motor
• Pnk
• Prk brk sw sig
• Run
• Seat belt ind
• Seat belt sw
• Seat belt sw low ref
• Start
• Tan
• Underhood fuse block (right front of engine compt)
• X104
• X207
• X208
• X210
• X307
• X500
• X600