STARTING/CHARGING – Chrysler Sebring Touring 2008 – SYSTEM WIRING DIAGRAMS

STARTING/CHARGING

Charging Wiring Diagram for Chrysler Sebring Touring 2008

List of elements for Charging Wiring Diagram for Chrysler Sebring Touring 2008:

• 2.4l
• A804
• Battery
• Battery remote positive post (left side of engine compt)
• Except 2.4l
• G100 (at bell housing near starter)
• Gen field ctrl
• Gen sens fused gen sens
• Generator
• K20
• Power distribution system
• Powertrain control module (left rear of engine compt)
• Red
• S130
• Starter

Starting Wiring Diagram for Chrysler Sebring Touring 2008

List of elements for Starting Wiring Diagram for Chrysler Sebring Touring 2008:

• (at left kick panel) g302
• 2.4l
• 2.7l
• 3.5l
• A/t
• Acc
• B (+)
• Battery
• Battery remote positive post (left side of engine compt)
• C10
• Can b bus (+)
• Can b bus (-)
• Can c bus (+)
• Can c bus (-)
• Clutch interlock sig
• Clutch interlock switch (m/t) (top of clutch pedal, on bracket)
• Computer data lines system
• D54
• D55
• D64
• D65
• Electronics
• Engine controls system
• Except 2.4l
• G100 (at bell housing near starter)
• G20
• G200 (at left end of dash)
• Generator
• Gnd
• Hold-in
• Ignition sw sens
• Ignition switch
• Key
• Key out
• Lock
• Powertrain control module (left rear of engine compt)
• Pull-in
• Red
• Run
• S128 (near battery jump posts)
• S130
• S194
• Sentry key remote entry/wcm module
• Start
• Starter
• Starter ctrl out
• T41
• T750
• Totally integrated power module (left side of engine compt)
• Transmission range sensor (40/41te) (on lower left side of transaxle)
• Transmission solenoid/trs assembly (62te) (left side of transaxle)
• Transmissions system
• Trs t41 sig
• Unlock