TRANSMISSION – Chrysler Sebring Limited 2001 – SYSTEM WIRING DIAGRAMS

TRANSMISSION

A/T Wiring Diagram (1 of 3) for Chrysler Sebring Limited 2001

List of elements for A/T Wiring Diagram (1 of 3) for Chrysler Sebring Limited 2001:

• (left front of engine compt) red
• (near a/t inline connectors)
• 2-4 press sw
• 2-4 pressure switch
• 2-4 sol ctrl
• 2-4 solenoid
• A24
• A41
• Auto stick dn sw
• Body control module (on junction block, at left end of dash)
• D21
• D25
• Eatx rpm sig
• F11
• Fuse 11 10a
• Fused (b+)
• Fused ign out
• G108 (left headlamp area)
• Gnd
• Hot in off, run or start
• Input spd sns sig
• Input speed sensor (on transmission, left of shift lever)
• Junction block
• K22
• K71
• Low/ reverse pressure switch
• Low/ reverse solenoid
• Low/rev press
• Low/rev sol ctrl
• Od press sw
• Od solenoid ctrl
• Output spd sns
• Output speed sensor (on left side of transmission case)
• Over- drive solenoid
• Overdrive pressure switch
• Pci bus
• Pnk
• Pnp sw sense
• Red
• S100
• S125
• S210
• Sci receive
• Sci transmit
• Sensor gnd
• Spd sensor gnd
• T10
• T13
• T14
• T15
• T16
• T19
• T20
• T41
• T42
• T44
• T47
• T50
• T52
• T54
• T59
• T60
• Torq mgmt req
• Tps sig
• Tr rng t42 sens
• Tr sw t1 sense
• Trans rly ctrl
• Trans rly out
• Trans temp sig
• Transmission control module (left front of engine compartment)
• Transmission solenoid/ pressure switch assembly (left side of transmission)
• Trs t41 sense
• Ud solenoid ctrl
• Under- drive solenoid
• Upshift sw sense
• Vss sig
• Z13
• Z14

A/T Wiring Diagram (2 of 3) for Chrysler Sebring Limited 2001

List of elements for A/T Wiring Diagram (2 of 3) for Chrysler Sebring Limited 2001:

• Acc
• Automatic day/night mirror & backup lights
• Automatic shutdown relay
• Autostick switch (if equipped) (integral with gearshift mechanism)
• Back-up lamp switch
• Engine starter motor relay
• Fuse 14 30a
• Fuse 8 20a
• Fuse 9 20a
• G103 (near left strut tower)
• G301 (left kick panel)
• Hall effect switches
• Hot at all times
• Ignition switch
• Lock
• Nol
• Off
• P3l
• Pnk
• Power distribution center
• Prnl
• Red
• Red/ tan
• Red/tan
• Run
• S102
• S104
• S112
• S313
• Start
• Trans temp sensor
• Transmission control relay
• Transmission range sensor (on lower left side of transmission)

A/T Wiring Diagram (3 of 3) for Chrysler Sebring Limited 2001

List of elements for A/T Wiring Diagram (3 of 3) for Chrysler Sebring Limited 2001:

• (near breakout to map/iat sensor)
• (near left front strut tower) g103
• (near pcm breakout) s121
• (on left kick panel, above hood release)
• A14
• Air conditioning & engine controls system
• D21
• D25
• Data link connector
• Eatm rpm sig
• Ect sensor sig
• Engine controls system
• Engine coolant temperature sensor (in water jacket, near thermostat housing)
• F12
• Fuse 10a
• Fuse 15a
• Fused b (+)
• G103 (near left front strut tower)
• Gnd
• Hot in run
• Hot in run or start
• Ign (run/start)
• Junction block
• K22
• K29
• K71
• P/n sw sense
• Pci bus
• Pnk
• Power distribution box
• Powertrain control module (left front of eng compt)
• Red/tan
• S105
• S110 (left side of eng compt)
• S115
• S117 (near breakout to cmp sensor)
• S126 (w/ abs)
• Sci transmit
• Sensor gnd
• Stop lp sw sense
• Stoplight switch (top of brake pedal)
• T10
• T41
• Throttle position sensor (on throttle body)
• Torque req sense
• Tp sens sig
• Vss signal
• Z108
• Z12