TRANSMISSION – Dodge Ram Van B3500 1998 – SYSTEM WIRING DIAGRAMS

TRANSMISSION

3 Speed A/T Wiring Diagram for Dodge Ram Van B3500 1998

List of elements for 3 Speed A/T Wiring Diagram for Dodge Ram Van B3500 1998:

• Automatic shutdown, fuel pump relays & duty cycle evap/ purge solenoid)
• B11
• Engine controls system
• Fuse 9 10a
• Hot in run or start
• Junction block
• K54
• Powertrain control module (center of firewall)
• S110
• S134
• Tcc ctrl
• Torque converter clutch solenoid (on left side of transmission)

4 Speed A/T Wiring Diagram (1 of 2) for Dodge Ram Van B3500 1998

List of elements for 4 Speed A/T Wiring Diagram (1 of 2) for Dodge Ram Van B3500 1998:

• (eng harn, before breakout for leak detection pump) s106
• (left side of dash)
• (main harn, in right trough)
• A14
• A16
• A17
• A22
• A23
• A31
• A32
• Automatic shutdown relay
• B11
• B21
• B25
• B27
• B28
• B29
• B30
• B31
• C13
• C24
• C25
• C27
• C28
• C29
• C30
• Ccd (+)
• Ccd bus(-)
• Cdd bus (+)
• Cdd bus (-)
• D20
• D21
• Ect sig
• Elec tr rly ctrl
• Engine controls system
• F18
• Fuse 10a
• Fused (b+)
• G114 (left rear of eng, on cylinder head)
• G202
• Generator
• Gov press sig
• Governor pressure signal
• Ground
• Hot in run & start
• Ign
• Instrument cluster
• Junction block
• K22
• K29
• K54
• K72
• Mil ind
• Od lp driver
• Od off sw sense
• Od sol ctrl
• Out spd sens gnd
• Out spd sens sig
• Overdrive lamp
• Overdrive solenoid control
• Overdrive switch
• Pnk
• Pnp sw sense
• Powertrain control module (center of firewall)
• S104 (eng harn, near pcm breakout)
• S107
• S110
• S203
• S204
• Sci receive
• Sci transmit
• Sensor gnd
• Sensor ground
• Stop lmp sw drive
• T13
• T14
• T18
• T24
• T25
• T30
• T34
• T59
• T60
• Tcc sol ctrl
• Torque converter clutch solenoid control
• Tps sig
• Trans temp sig
• Transmission relay output
• Transmission solenoid assembly (on left side of transmission)
• Transmission temperature sensor signal
• Var sol ctrl
• Variable force solenoid control
• Vss sig
• Warning lamp drive
• Z12

4 Speed A/T Wiring Diagram (2 of 2) for Dodge Ram Van B3500 1998

List of elements for 4 Speed A/T Wiring Diagram (2 of 2) for Dodge Ram Van B3500 1998:

• (eng harn, before breakout for leak detection pump) s115
• (eng harn, near breakout for pcm, conn c1)
• (eng harn, near breakout to throttle position sensor)
• Automatic shutdown relay
• Closed in p&n positions
• Controller anti-lock brake (near water reservoir, attached to hydraulic control unit)
• D20
• D21
• Data link connector (below steering column)
• Engine controls system
• Engine coolant temperature sensor (in water jacket, at front of intake manifold)
• F75
• Fuse 17/18 20a
• Fuse 20a
• G114 (left rear of eng, on cylinder head)
• G116 (left side of firewall)
• Hot at all times
• Junction block
• Manifold absolute pressure sensor
• Others
• Output shaft speed sensor (on bottom of transmission)
• Park/neutral position switch (on left lower side of transmission)
• Pnk
• Power amplifier
• Power distribution center
• S114 (eng harn, in branch to stop lamp switch)
• S115
• S121
• S127 (eng harn, near breakout to automatic transmission switch)
• S128
• S129
• S132 (eng harn, near breakout to alternator ground)
• S133
• Starting/ charging system (engine starter motor relay)
• Stop lamp sw sense
• Stop lamp switch (on brake pedal bracket)
• Throttle position sensor (on throttle body assembly)
• Transmission relay (in pdc)
• Vss sig
• W/ power amplifier
• Z12
• Z40