ANTI-LOCK BRAKES – Ford Aerostar 1995 – SYSTEM WIRING DIAGRAMS

ANTI-LOCK BRAKES

Anti-lock Brake Wiring Diagrams for Ford Aerostar 1995

List of elements for Anti-lock Brake Wiring Diagrams for Ford Aerostar 1995:

• (behind left side of instrument panel, taped to main harness)
• (on brake pedal support)
• (top of rear axle)
• Acc
• Brake fluid level switch (left rear of engine compartment, on brake master cylinder)
• Brake input
• Brake on/off (boo) switch
• Diag input/kapr
• Diff sensor ground
• Diff speed input
• Differential speed sensor
• Dss input
• Dss return
• Dss test connector (left rear of engine compt)
• Dump sol output
• Dump solenoid
• Dump valve solenoid
• Fuse 15a
• Fuse 20a
• Fuse panel
• G100 (front of left fender apron, left of battery)
• G206 (behind center of instrument panel, below left side of radio)
• G206 (behind center of i/p, below left side of radio)
• Hot at all times
• Hot in run
• Hot in start or run
• Ignition switch
• Instrument cluster
• Instrument cluster system
• Isolation sol output
• Isolation valve solenoid
• Lock
• Low fluid lvl input
• Module ground
• Nca
• Off
• Pressure differential warning switch (left rear of engine compartment, below brake fluid reservoir)
• Psom module (instrument cluster)
• Rabs proportioning valve switch assembly (left rear of engine compartment, below master cylinder)
• Rabs test connector
• Rear abs indicator
• Rear anti-lock brake module (rabs) (behind center of i/p, below ashtray)
• Red
• Red/pnk
• Run
• Start
• Switched power
• Valve reset
• Warning lamp