CRUISE CONTROL – Oldsmobile Alero GX 2003 – SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

Cruise Control Wiring Diagram for Oldsmobile Alero GX 2003

List of elements for Cruise Control Wiring Diagram for Oldsmobile Alero GX 2003:

• (2.4l vin t)
• (3.4l vin e)
• A/t
• Alero only
• B12
• B4 c1
• Body control module (behind right side of dash)
• Brake input 1
• Brake input 2
• Cancel
• Clutch pedal position switch (m/t) (above clutch pedal, on bracket)
• Cpp switch sig (m/t)
• Cruise cancel sig
• Cruise control module (right side of engine compt)
• Cruise control on/off switch
• Cruise disable input
• Cruise disable output
• Cruise engaged input
• Cruise engaged output
• Cruise fuse 10a
• Cruise on input
• Cruise release (a/t)
• Cruise sw fuse 2a
• Exterior lights system
• G101 (left front shock tower)
• G201 (left side of dash)
• Ground
• Hot in run
• Ignition
• Inflatable restraint steering wheel module coil
• Left i/p fuse block (behind left side of dash)
• M/t
• Off
• Powertrain control module (pcm) (below left side of dash)
• R/a
• Resume/accel input
• Right i/p fuse block (behind right side of dash)
• S/c
• Set/coast input
• Splice pack sp101
• Splice pack sp201
• Tcc/brake switch (a/t) (below left side of dash)
• Underhood fuse block (left side of engine compartment)
• Underhood fuse block (left side of engine compt)
• Vehicle speed sensor (vss) (on rear of engine/transaxle)
• Vss high
• Vss input
• Vss low
• Vss output