COOLING FAN – Chevrolet Spark LT 2013 – SYSTEM WIRING DIAGRAMS

COOLING FAN

Cooling Fan Wiring Diagram for Chevrolet Spark LT 2013

List of elements for Cooling Fan Wiring Diagram for Chevrolet Spark LT 2013:

• Computer data lines system
• Coolant temp sens 2 low ref
• Coolant temp sens 2 sig
• Coolant temp sens low ref
• Cooling fan high speed relay
• Cooling fan low speed relay
• Cooling fan motor (behind radiator)
• Cooling fan resistor (left front corner of engine compt)
• Emis 1 fuse 15a
• Emis 2 fuse 15a
• Eng coolant temp sens sig
• Engine control module (ecm) (near battery)
• Engine coolant temperature ind
• Engine coolant temperature sensor 1 (near thermostat)
• Engine coolant temperature sensor 2 (right side radiator tank)
• Engine coolant thermostat heater (thermostat housing)
• Fan hi fuse 30a
• Fan lo fuse 20a
• G101 (near left headlamp assembly)
• G202
• Ground
• Hi speed cooling fan relay ctrl
• High speed gmlan serial data (+) (1)
• High speed gmlan serial data (-) (1)
• Hot at all times
• Hot w/ engine controls ignition relay energized
• Hot w/ ignition run relay energized
• Instrument cluster
• Instrument panel fuse block (left end of dash)
• Ipc i/p ind fuse 15a
• J109 (engine harness, near ignition control module)
• J150
• J239
• J252
• Lo speed cooling fan relay ctrl
• Logic
• Run/crank ign 1 volt
• Serial data low speed gmlan
• Thermostat engine cool control
• Underhood fuse block (left rear corner of engine compt)
• X111