TRANSMISSION – Chevrolet Spark LT 2013 – SYSTEM WIRING DIAGRAMS

TRANSMISSION

Transmission Wiring Diagram (1 of 2) for Chevrolet Spark LT 2013

List of elements for Transmission Wiring Diagram (1 of 2) for Chevrolet Spark LT 2013:

• (near starter) g104
• Access wakeup ser data
• Battery positive volt
• Computer data lines system
• Ecm/tcm1 fuse 15a
• Ecm/tcm2 fuse 15a
• G104 (near starter)
• Gnd
• Hi spd gmlan data (+) 1
• Hi spd gmlan data (-) 1
• Hot at all times
• Hot w/ ignition run relay energized
• Input sp sens low ref
• J140
• J154
• Oil temp sens low ref
• Oil temp sens sig
• Output sp sens low ref
• Park position switch
• Park/neutral position switch (integral to transmission shift lever)
• Posin sw parity bit sig
• Power distribution system
• Run/crank ign 1 volt
• Shift selector mode sig
• Shift sol ctrl (3)
• Shift sol ctrl (4)
• Shift sol low ref (1)
• Shift sol low ref (2)
• Shift sol low ref (3)
• Shift sol sply volt (1)
• Shift solenoid ctrl (5)
• Starting/ charging system
• Tcc/clutch sol ctrl
• Tcc/clutch sol low ref
• Trans posin sw bit 1 sig
• Trans posin sw bit 2 sig
• Trans posin sw bit 3 sig
• Trans posin sw bit 4 sig
• Transmission control module (on steering column)
• Underhood fuse block (left rear corner of engine compt)

Transmission Wiring Diagram (2 of 2) for Chevrolet Spark LT 2013

List of elements for Transmission Wiring Diagram (2 of 2) for Chevrolet Spark LT 2013:

• (in automatic transmission) control solenoid valve assembly
• Computer data lines system
• Driver information center display
• Instrument cluster
• Lo gm gmlan
• Logic
• Pressure control solenoid valve 1
• Pressure control solenoid valve 2
• Pressure control solenoid valve 3
• Shift solenoid valve 1
• Torque converter clutch pressure control solenoid valve
• Transmission fluid temperature sensor
• Transmission input shaft speed sensor
• Transmission output shaft speed sensor (on transmission, near the axle shafts)