CRUISE CONTROL – Chevrolet Impala LT 2012 – SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

Cruise Control Wiring Diagram (1 of 2) for Chevrolet Impala LT 2012

List of elements for Cruise Control Wiring Diagram (1 of 2) for Chevrolet Impala LT 2012:

• (above starter motor) g111
• 5 volt ref
• 5 volt ref 1
• 5 volt ref 2
• App sens 1 sig
• App sens 2 sig
• Body control module (bcm) (left side of dash)
• Brake pedal position sensor (left side of dash)
• Computer data lines system
• Cruise ctrl ind sig
• Cruise ctrl sw sig
• Cruise ind
• Ecm ign fuse 10a
• Engine control module (ecm) (inside air cleaner assembly)
• Gnd
• Hot w/ ign main pcb relay energized
• Ign
• Ign 1 voltage
• Inflatable restraint steering wheel module coil (under steering wheel)
• Instrument panel cluster (ipc)
• Logic
• Low ref
• Pnk
• Serial data
• Serial data +
• Serial data -
• Sply voltage
• Steering ctrl sig
• Stop lamp sw sig
• Tac motor ctrl 1
• Tac motor ctrl 2
• Tan
• Tp sensor sig
• Underhood fuse block (right side of engine compt)
• X111
• X201
• X275
• X277

Cruise Control Wiring Diagram (2 of 2) for Chevrolet Impala LT 2012

List of elements for Cruise Control Wiring Diagram (2 of 2) for Chevrolet Impala LT 2012:

• (top of engine) throttle body
• Accelerator pedal position (app) sensor (left side of dash)
• Cruise on ind
• Down seek
• Info
• J213 (steering wheel harness, behind inflatable restraint steering wheel module)
• Left steering wheel control switch
• On/off cancel
• Res+
• Right steering wheel control switch
• Seek up
• Set-
• Srce
• Tan
• Voice
• Vol down
• Vol up
• W/ steering wheel accessory control
• W/o steering wheel accessory control
• X111