CRUISE CONTROL – Chevrolet Malibu LTZ 2008 – SYSTEM WIRING DIAGRAMS

CRUISE CONTROL

Cruise Control Wiring Diagram for Chevrolet Malibu LTZ 2008

List of elements for Cruise Control Wiring Diagram for Chevrolet Malibu LTZ 2008:

• (behind steering wheel, in steering column) inflatable restraint steering wheel module coil
• 2.4l (vin 5) & 3.6l
• 2.4l (vin b)
• 5 volt ref 1
• 5 volt ref 2
• 5v ref
• Accelerator pedal position sensor (app) (attached to accelerator pedal)
• App sens 1 sig
• App sens 2 sig
• Body control module (bcm) (under right side of center console)
• Brake pedal position sensor (on brake pedal support)
• Brk pos sens sig
• Cluster/theft fuse 10a
• Computer data lines system
• Cruise control switch signal
• Cruise indicator
• Cruise on ind
• Cruise on/off switch
• D12
• Engine control module (ecm) (left side of engine compt, near battery)
• G201 (under center console, on right side of front support bracket, next to g203, near bcm)
• Gmlan
• Gmlan serial data bus+
• Gmlan serial data bus-
• Gnd
• Hot at all times
• Hot w/ run/crank relay energized
• Ibcm (run/ crank) fuse 21 30a
• Ibcm 1 fuse 20
• Ign
• Instrument panel cluster (ipc)
• J201
• J209 (w/ tap up/ tap down) (behind inflatable restraint wheel module)
• Left steering wheel control switch
• Logic
• Low ref
• Low speed gmlan serial data
• Oss high sig
• Oss low sig
• Pnk
• Res +
• Run/crank fuse 2a
• Serial data
• Set -
• Stoplamp sw
• Stoplamp sw sig
• Tac motor ctrl 1
• Tac motor ctrl 2
• Tan
• Tap sens 1 sig
• Tap sens 2 sig
• Throttle actuator control (tac) module (on throttle body)
• Transmission control module (tcm) (left rear of engine compt, near strut tower)
• Underhood fuse block (on left side of engine compt)
• Vehicle speed sensor (2.4l (vin 5) & 4 speed a/t) (on right side of transmission)