ANTI-LOCK BRAKES – Toyota Tundra 2006 – SYSTEM WIRING DIAGRAMS

ANTI-LOCK BRAKES

Anti-lock Brakes Wiring Diagram, Access/Standard Cab without VSC for Toyota Tundra 2006

List of elements for Anti-lock Brakes Wiring Diagram, Access/Standard Cab without VSC for Toyota Tundra 2006:

• (behind upper left side of dash, near instrument cluster) (a/t) diode
• (behind upper left side of dash, near instrument cluster) j/c 8
• (below left side of dash, near center console) data link connector 3
• +bm
• +bs
• A/t
• Abs 2 fuse 50a
• Abs 3 fuse 30a
• Abs actuator w/ ecu (in right rear corner of engine compartment)
• Abs deceleration sensor (access cab: under front of center console) (standard cab: under right front seat)
• Abs ind
• Acc fuse 15a
• Active circuit
• C11
• C12
• Combination meter
• Control circuit
• D j66
• D/g
• Driver side j/b (behind lower left side of dash)
• E16
• Ecu ig fuse 5a
• Engine room r/b (on left side of engine compt)
• Exi
• Exi4
• F10
• Fl+
• Fl-
• Fr+
• Fr-
• G11
• G13
• Gauge fuse 10a
• Ggnd
• Gl1
• Gnd1
• Gnd2
• Hot at all times
• Hot in on or acc
• Hot in on or start
• I16
• Ig1
• Ih (behind right kick panel)
• J/c 10 (behind upper left side of dash, near instrument cluster)
• J/c 13 (behind right kick panel)
• J/c 28 & 29 (behind upper right side of dash, near passenger's air bag) j29
• J/c 66 & 67 (behind right kick panel)
• J/c 66 (behind right kick panel)
• J/c 8 (behind upper left side of dash, near instrument cluster)
• J/c 9 (behind upper left side of dash, near instrument cluster)
• J28
• Left
• Left front abs speed sensor (at left front steering knuckle assembly)
• Nca
• Park/neutral position switch (a/t) (on transmission)
• Pnk
• Rear abs speed sensor (on left side of rear axle)
• Red
• Right
• Right front abs speed sensor (at right front steering knuckle assembly)
• Rl+
• Rl-
• Rr+
• Rr-
• Sil
• Spi
• Stop fuse 15a
• Stoplight switch (on bracket, above brake pedal)
• Stp
• Transmissions system
• Vgs

Anti-lock Brakes Wiring Diagram, Access/Standard Cab withVSC (1 of 2) for Toyota Tundra 2006

List of elements for Anti-lock Brakes Wiring Diagram, Access/Standard Cab withVSC (1 of 2) for Toyota Tundra 2006:

• (at left rear of engine compt) skid control ecu w/ actuator
• (behind right kick panel) j/c 66 & 67
• +bm1
• +bm2
• +bs
• A/t
• Abs 2 fuse 50a
• Abs 3 fuse 30a
• Abs ind
• Active circuit
• Auto lsd ind
• Brake fluid level warning switch (on brake fluid reservoir)
• Brake ind
• Brl
• C11
• C12
• Canh
• Canl
• Combination meter
• Csw
• D/g
• E11
• E12
• Ea (on left front fender)
• Engine room r/b (on left side of engine compt)
• Et (4.0l: on right side of engine compt) (4.7l: right front fender)
• Exi
• Exi4
• Fl+
• Fl-
• Fr+
• Fr-
• Gnd1
• Gnd2
• Gnd3
• Hot at all times
• I24
• Ig1
• Ig2
• Ih (behind right kick panel)
• Ind
• Infr
• Integration control & panel
• J/c 18 (on left side of engine compt, under engine room r/b)
• J/c 3 (behind left kick panel)
• J/c 4 (behind left kick panel)
• J/c 66 & 67 (behind j67 right kick panel)
• J66
• J67
• Lbl
• Left
• Left front abs speed sensor (at left front steering knuckle assembly)
• M/t
• Parking brake switch (on base of park brake pedal bracket, near kick panel)
• Pkb
• Pnk
• Rear abs speed sensor (on left side of rear axle)
• Red
• Right
• Right front abs speed sensor (at right front steering knuckle assembly)
• Rl+
• Rl-
• Rr+
• Rr-
• S29
• S30
• Slip ind
• Sp1
• Stp
• Stp2
• Stpo
• Transmissions system
• Vsc off ind
• Vsc trac ind
• Vscw
• Wfse

Anti-lock Brakes Wiring Diagram, Access/Standard Cab withVSC (2 of 2) for Toyota Tundra 2006

List of elements for Anti-lock Brakes Wiring Diagram, Access/Standard Cab withVSC (2 of 2) for Toyota Tundra 2006:

• (behind upper left side of dash, near instrument cluster) (a/t) diode
• (behind upper left side of dash, near instrument cluster) j/c 8 & 9
• (behind upper left side of dash, near instrument cluster) j/c 9
• Acc fuse 15a
• Bat
• Canh
• Canl
• Data link connector 3 (below left side of dash, near center console)
• Driver side j/b (behind lower left side of dash)
• E12
• Ecu-b fuse 5a
• Ecu-ig fuse 5a
• Engine control module (behind right side of dash)
• Engine room r/b (on left side of engine compt)
• Ess
• F10
• F11
• G11
• G13
• Gauge fuse 10a
• Gnd1
• Hot at all times
• Hot in acc or on
• Hot in on or start
• Ie (behind left kick panel)
• Ig1
• Ign fuse 5a
• Ih (behind right kick panel)
• Ii (behind right
• J/c 10 (behind upper left side of dash, near instrument cluster)
• J/c 12 (behind upper right side of dash, near passenger's airbag)
• J/c 23 & 24 (behind left end of dash)
• J/c 26 & 27 (behind left kick panel)
• J/c 28 & 29 (behind upper right side of dash, near passenger's airbag)
• J/c 66 & 67 (behind right kick panel)
• J/c 68, 69, 70, 71, 72 & 73 (behind upper left side of dash, near instrument cluster)
• J/c 8 (behind upper left side of dash, near instrument cluster)
• J/c 9 (behind upper left side of dash, near instrument cluster)
• J23
• J24
• J26
• J27
• J28
• J29
• J66
• J67
• J68
• J69
• J70
• J71
• J72
• J73
• Kick panel)
• Park/neutral position switch (on transmission)
• Pnk
• Red
• Sil
• Steering sensor (on upper steering column)
• Stop fuse 15a
• Stop light relay (behind left side of dash)
• Stop light switch (on bracket, above brake pedal)
• Vsc warning buzzer (behind center of dash)
• W/ engine immobiliser system
• W/o engine immobiliser system
• Wfse
• Yaw rate sensor (under right front seat)

Anti-lock Brakes Wiring Diagram, Double Cab with VSC (1 of 2) for Toyota Tundra 2006

List of elements for Anti-lock Brakes Wiring Diagram, Double Cab with VSC (1 of 2) for Toyota Tundra 2006:

• (at left rear of engine compt) skid control ecu w/ actuator
• (behind right side of dash) j/c 75
• +bm1
• +bm2
• +bs
• A13
• Abs 1 fuse 40a
• Abs 2 fuse 30a
• Abs ind
• Active circuit
• Auto lsd ind
• Brake fluid level warning switch (on brake fluid reservoir)
• Brake ind
• Brl
• C11
• C12
• Canh
• Canl
• Combination meter
• Csw
• D/g
• Driver side j/b (under left end of dash)
• Em (at right front of engine compt)
• Exi
• Exi4
• Fl+
• Fl-
• Fr+
• Fr-
• Fusible link block (on left side of engine compt)
• Gnd1
• Gnd2
• Gnd3
• Hot at all times
• I24
• Ig1
• Ig2
• Ind
• Infr
• Integration control & panel
• J/c 45 (behind left side of dash)
• J/c 58 (behind right side of dash)
• K12
• Lbl
• Left
• Left front abs speed sensor (at left front steering knuckle assembly)
• Parking brake switch (on base of park brake pedal bracket, near kick panel)
• Pkb
• Pnk
• Rear abs speed sensor (on left side of rear axle)
• Red
• Right
• Right front abs speed sensor (at right front steering knuckle assembly)
• Rl+
• Rl-
• Rr+
• Rr-
• S29
• S30
• Slip ind
• Sp1
• Stp
• Stp2
• Stpo
• Sub j/b 3 (behind center of dash)
• Transmissions system
• Vsc off ind
• Vsc trac ind
• Vscw
• Wfse

Anti-lock Brakes Wiring Diagram, Double Cab with VSC (2 of 2) for Toyota Tundra 2006

List of elements for Anti-lock Brakes Wiring Diagram, Double Cab with VSC (2 of 2) for Toyota Tundra 2006:

• (behind center dash) sub j/b 4
• (behind center of dash) sub j/b 3
• (behind right side of dash) j/c 28 & 29
• A18
• Bat
• Canh
• Canl
• D10
• Data link connector 3 (below left side of dash, near center console)
• Driver side j/b (under left end of dash)
• E10
• E17
• Ecu-b fuse 7.5a
• Ecu-ig fuse 10a
• Engine control module (behind right side of dash)
• Engine room j/b (on left side of engine compt)
• Ess
• Gauge fuse 15a
• Gnd
• H11
• Hot at all times
• Hot in on or start
• Ig1
• Ign 1 fuse 10a
• Ipo
• J/c 31 (on left side of engine compt, under engine room r/b)
• J/c 47 & (behind left side of dash)
• J/c 54 (behind center of dash)
• J/c 58 (behind right side of dash)
• J/c 76, 77, 78, 79, 80 & 81 (behind right side of dash)
• J28
• J29
• J47
• J48
• J76
• J77
• J78
• J79
• J80
• J81
• Park/neutral position switch (on transmission)
• Pnk
• Sil
• Steering sensor (on upper steering column)
• Stop fuse 15a
• Stop light relay
• Stop light switch (on bracket, above brake pedal)
• Sub j/b 3 (behind center of dash)
• Sub j/b 4 (behind center of dash)
• Vsc warning buzzer (behind center of dash)
• Wfse
• Yaw rate sensor

Anti-lock Brakes Wiring Diagram, Double Cab without VSC for Toyota Tundra 2006

List of elements for Anti-lock Brakes Wiring Diagram, Double Cab without VSC for Toyota Tundra 2006:

• (behind left side of dash) j/c 45
• +bm
• +bs
• Abs 1 fuse 60a
• Abs 2 fuse 30a
• Abs actuator w/ ecu (in right rear corner of engine compt)
• Abs deceleration sensor (front passenger seat)
• Abs ind
• Active circuit
• Alt fuse 140a
• C11
• C12
• Combination meter
• Control circuit
• D/g
• Data link connector 3 (below left side of dash, near center console)
• Driver side j/b (under left end of dash)
• Ecu ig fuse 10a
• Exi
• Exi4
• F15
• Fl+
• Fl-
• Fr+
• Fr-
• Fusible link block (on left side of engine compt)
• G j29
• Gauge fuse 15a
• Ggnd
• Gl1
• Gnd1
• Gnd2
• H11
• Hot at all times
• Hot in on or start
• Ig1
• Ign1 fuse 10a
• Ipo
• J/c 28 & 29 (behind right side of dash)
• J/c 31 (on left side of engine compt, under engine room r/b)
• J/c 47 (behind left side of dash)
• J/c 48 (behind left side of dash)
• J/c 58 (behind right side of dash)
• J28
• K10
• Left
• Left front abs speed sensor (at left front steering knuckle assembly)
• Nca
• Park/neutral position switch (on transmission)
• Pnk
• Rear abs speed sensor (on left side of rear axle)
• Red
• Right
• Right front abs speed sensor (at right front steering knuckle assembly)
• Rl+
• Rl-
• Rr+
• Sil
• Spi
• Stop fuse 15a
• Stop light switch (on bracket, above brake pedal)
• Stp
• Sub j/b 3 (behind center of dash)
• Transmissions system
• Vgs