SUPPLEMENTAL RESTRAINTS – Toyota Tundra 2001 – SYSTEM WIRING DIAGRAMS

SUPPLEMENTAL RESTRAINTS

Supplemental Restraint Wiring Diagram for Toyota Tundra 2001

List of elements for Supplemental Restraint Wiring Diagram for Toyota Tundra 2001:

• Acc
• Acc fuse 15a
• Air bag squib (front passenger air bag assembly)
• Air bag squib (steering wheel pad)
• Bench seat
• C11
• Center air bag sensor assembly (behind lower center of dash, on transmission tunnel)
• Combination meter
• Connection detection pin
• Data link connector (dlc) 3 (partial) (under left side of dash, near center console)
• Driver side j/b (behind lower left side of dash)
• Ecu+
• Ecu-
• Ecu-b fuse 5a
• G10
• G200
• G200 (left kick panel)
• G203
• G203 (right kick panel)
• Gnd
• Gnd1
• Hot at all times
• Hot in acc or on
• Hot in on or start
• I24
• I25
• Ig2
• Ign fuse 5a
• Ind
• Integration control & panel
• J/c 13 (right kick panel)
• J/c 14 (under driver's seat)
• J/c 3 (behind left kick panel)
• J/c 5 (behind left side of dash)
• J/c 5 (behind upper left side of dash, near combination meter)
• Lbe+
• Left buckle switch inside driver's seat belt buckle)
• Left front air bag sensor (on front left side of engine compartment, behind headlight)
• Left pretensioner
• Passenger air bag manual on-off switch
• Pind
• Pl+
• Pl-
• Pr+
• Pr-
• Rbe+
• Red
• Right front air bag sensor (on front right side of engine compartment, behind headlight)
• Right pretensioner
• Seat belt warning occupant detection sensor
• Sil
• Sl+
• Sl-
• Spiral cable
• Sqb+
• Sqb-
• Sr+
• Sr-
• Srs warning light
• W/o power seat
• W/power seat