TRANSMISSION
4WD Wiring Diagram, Shift on the Fly for Isuzu Rodeo S 2004
https://portal-diagnostov.com/license.html
https://portal-diagnostov.com/license.html
Automotive Electricians Portal FZCO
Automotive Electricians Portal FZCO List of elements for 4WD Wiring Diagram, Shift on the Fly for Isuzu Rodeo S 2004:
- (3.2l) (at right side
- (3.5l: left rear of engine compartment) (3.2l: at left rear corner of engine compartment, on inner fender panel) c16
- (a/t)
- (at right side of intake manifold) (m/t) e30
- (m/t)
- (on right rear corner of engine compartment) electronic brake control module (ebcm)
- (under left side of dash) transmission control module
- 2-4wd switch
- 2h sw
- 4h ind
- 4h sw
- 4l ind
- 4l ind light
- 4l sw
- 4l-out
- 4l-signal
- 4wd engage
- 4wd ind light
- 4wd sig
- 4wd sw
- A/t circuit
- Automatic transmission mode switch (on right side of transmission)
- Axl-m1
- Axl-m2
- Axle sw
- B-19
- B-42
- Battery
- Brakes system
- C-4
- C-79
- C16 (3.5l: left rear of engine compartment) (3.2l: at left rear corner of engine compartment, on inner fender panel)
- Check 4wd warning light
- Check ind
- Dash fuse box (behind left side of dash, behind panel)
- Drive selector switch
- E30 e21 (3.5l) (top front of of intake manifold)
- Engine)
- Front axle motor actuator (on left side of front axle)
- Fuse 11 meter 15a
- Fuse 14 back up/ turn light 15a
- Fuse 14 tcm & tccm 10a
- Fuse/ relay box (on right side of engine compt)
- Gnd
- Ground
- Hot at all times
- Hot in on or start
- I-1
- I-2
- Ignition
- Interior lights system
- Limit sw1
- Limit sw2
- Limit sw3
- Limit sw4
- Ls1-sw
- Ls2-sw
- Ls3-sw
- Ls4-sw
- M/t
- Meter assembly
- N sw
- Neutral switch
- Neutral switch (m/t)
- Red
- Shift motor
- T/f-m1
- T/f-m2
- T/m 1-sw
- Tach sig
- Transfer actuator (a/t: on rear of transmission) (m/t: beneath center of vehicle, on transfer case)
- Transfer control unit (below center console)
- Vehicle speed sensor (m/t) (m/t: on rear of transmission) (a/t: underside of vehicle, on transmission)
- Vss sig
A/T Wiring Diagram for Isuzu Rodeo S 2004
List of elements for A/T Wiring Diagram for Isuzu Rodeo S 2004:
- (3.2l)
- (3.2l) (3.5l)
- (3.5l)
- (3.5l: top front of engine) (3.2l: at right side of intake manifold)
- (on right side of transmission) automatic transmission mode switch
- (right side of transmission)
- (under left side of dash) transmission control module
- 3.2l
- 3.5l
- 4l-signal
- A/t fluid ind light
- A/t oil ind
- Alarm & relay control unit (behind right side of dash, above right kick panel)
- Automatic transmission
- B-19
- B-42
- Battery
- Brake
- Brake switch (behind left side of dash, on brake pedal support)
- C-74
- C-78
- C-79
- Can+
- Can-
- Check trans ind light
- Chk tran ind
- Cruise control system
- Dash fuse box (behind left side of dash, behind panel)
- Data link connector (dlc) (below left side of dash, near engine hood release)
- Dgi
- E-22
- E30 e21
- Engine control module (3.2l: left rear of engine compt) (3.5l: left side of engine compt)
- Exterior lights system
- Fuse 11 meter 15a
- Fuse 14 back up/ turn light 15a
- Fuse 14 tcm & tccm 10a
- Fuse 18 tcm 15a
- Fuse 6 stop light 15a
- Fuse/ relay box (on right side of engine compt)
- Ground
- Hot at all times
- Hot in on or start
- I-1
- I-2
- I-42
- I-9
- Ignition
- Input revolution sensor (3.5: dinear left front exhaust downpipe) (3.2l: left side of transmission)
- Interior lights system
- J1850
- Meter assembly
- Nco
- Ncog
- Oil temp sensor 1
- Ot1
- Ot1g
- Ot2
- Ot2g
- Output revolution sensor (on right side of automatic transmission)
- Pnk
- Pressure control solenoid
- Red
- Shift indicator
- Sl/slu
- Slug
- Solenoids
- Sp2
- Sp2g
- Sth
- Sthg
- Transfer control unit (below center console)
- Transmission oil temp sensor
- Winter
- Winter drive ind light
- Winter ind
- Winter sw
- Winter switch